Wireless

Does anyone know of a way to send the 'WLAN ID' value from the WLC to the ACS accounting server. It would be nice if we had accounting on which SSID(WLAN ID) the user was connecting to in our logs.I tried accepting every possible field in the ACS but...

The following problem is faced when cisco ip phones 7921 are roaming between APs:When a call is establishedon wireless ip phones, and the phones are roaming between APs, a three seconds gap appears but the call doesn't disconnect.The following log me...

When I add useraccounts in WCS (5.1.65.4), the accounts always stays in the list of guest users even though they are expired. Is this a bug or is it supposed to behave this way? Under status it says active on all accounts, but if i click one account ...

HI! Can Cisco AP 1121 act as repeater? Yes it can. But my question is - can I use this AP to connect to a wireless network via wireless, and then connect my PC to this AP, so I can access internet? I hope you understand my question. (I attached a pic...

Hello - I have about 60 shops over the US and each shop has 1 autonomous access point. I have one at my corporate location as well. Does Cisco have anything that would allow me to manage and monitor all the access points across my WAN from our corpor...

Hi,We have a 1200 Aironet AP which had been working fine. The image directory was deleted from the AP with the "delete /recursive ...." command.We TFTP a new image file namely:c1200-k9w7-tar.123-8.JEB.tarHowever when we reboot the Access Point it com...

My customer who has one WLC4402,36 AP1130.Some of APs miss from WLC sometimes but I can ping those APs at this time.I can not find any messages from WLC(version 4.2.61).Any suggestions?

Are there any recommendations for load thresholds for n access points? I know that with n the APs should be able to handle more connections than their g counterparts.I have done tests where 29 clients have been attached to one 1252 with little or no ...

I have an 1131AG (autonomous) that was previously configured with the mode button disabled. As a result, I cannot hold it down on power up to restore a default configuration. I do not know the login for the AP to undo the configuration of the mode bu...

What is cisco best practice for a LWAPP port on an edge switch. WLAN is using 7921 handsets.Should I use STP portfast ?What QOS marking on the access port.### current ####int fa0/1switchportswitchport mode accessswitchport access vlan 10mls qos trust...

Currently one of my customers is running Autonomous IOS version 12.3(7)JA.He wants WEP and WPA support and in future wants to able to be convert from Autonomous to LWAPP.According to the following link version 12.3(7)JA should allow him to go to LWAP...

Hi,We are setting up Tacaacs to a WLC 4404 , but we are getting the following message on the WLC when we try and go through the management IP using tacaacs. Anyone seen this b4.Jan 29 13:23:28.012 ews_auth.c:2107 EMWEB-1-LOGIN_FAILED: Login failed. U...

I am planning to split AP's between 2 WLC's. Also need to configure DHCP option 43, since the Management and AP-Manager interfaces will be on a different VLAN than APs.Is Option 43 going to overwrite the primary/secondary controller configuration on ...

We have a autonomous wireless setup with a WLSM and WLSE. I have an issue with where I have 2 wirless clients that need to communicate using a multicast address for an application to work.The clients can ping each other but the multicast stream is no...