Wireless

I can get a linux client (debian using atheros card) working fine with no authentication in open mode.However, if I set up 128bit WEP (4 keys) and enter those exact keys on my linux client. It can't associate.I've quadruple checked the keys on both t...

Hi NetPro,anyone who knows ACS 4.1 - Generate Self-Signed Certificate and Generate Certificate Signing request are only valid for 1 year ? How about 1 year later ? If I re-generate the Certificate will it be affected to my current authenticate users ...

Hi, we have found a specular error on the radio interface of the Access Point.Errors on the Radiso Interface area as below.Dot11Radio0 is up, line protocol is up 47575 output errors, 0 collisions, 4 interface resets 0 babbles, 0 late collis...

Looking in the WCS reporting, Performance and selecting an AP gives some clues about the AP behavior. I have always increased "FCS error rate for a/n and b,g interfaces" on daytime, with high figures on the y-axis. I assume the figure is a summary (i...

Hello.. We have about a dozen AP1220B that is not accepting any client connection.I have a Broadcom 4321AG 802.11a/b/g/draft-n adapter on my laptop and are using both NetStumbler and Braodcom Wireless Util for diagnostic and testing of the APs. I'm ...

Hi, my network have 4 AP 1240 configured how root AP. These APs use WPA-EAP (MS-CHAPV2) with radius and are working fine.Now I need install another AP how repeater. Using WPA-EAP don't work. I tested using WPA-PSK and work fine.Anyone can help me.Tha...

have a cisco 1100 series.we are going to be at a show with multiple vendors in the building.most every vendor has their own office in this building, with their own wireless network setup.when our users power on their laptops they normally see 7 to 8 ...

Is there any type of encrytion between an access point and a pc? is the data encrypted ?

I?ve been having considerable problems with getting clients to access the internet via a guest wireless DMZ controller. I have a 4402 in the DMZ and a 4404 in the LAN; I have ping, mping & Eping connectivity between the controllers. I have configured...

I have (2) buildings connected with 1300 bridges. I have routers behind both bridges peering with EIGRP. Everything works fine when setting it up and testing. When we go live, and have the users go over the wireless link, after about 15 minutes the b...

I've install 1310 access point but the signal is really weak, i was wondering if i could just add a amplifier to it?

What equipment would I need to build a WLAN on a school campus that will be soley for Internet access, with persons being able to access the net both inside and outside of buildings? The coverage area consists of 7 buildings with each being within 30...

We have two SSIDs - one for the corporate network and one for the guest network.The corporate network uses PEAP for authentication and the Guest is open (separate vlans, etc).I need a way to keep the corporate users off of the guest network (so they ...

I've AP 1121G -here config-dot11 ssid 354783729734 authentication open authentication key-management wpa wpa-psk ascii xxx!!!interface Dot11Radio0 no ip address no ip route-cache ! encryption mode ciphers tkip ! ssid 354783729734 !Client -Cis...

How man wirelesslancontrollers are permited configure into the same mobility group?