Wireless

Some mayor companies dropped their support on Pocket PC 2003 PDAs and don't deliver the upgrade to WM 2003SE or higher. On this website: http://www.windowsecurity.com/articles/80211i-WPA-RSN-Wi-Fi-Security.htmlis a reference to WPA client software fo...

Hi,Here is my portion of ACL List applied on the Controller CPU.- permit 192.168.1.0/24 0.0.0.0 UDP DHCPServer DHCPCLient Any Outbound- Permit 0.0.0.0 192.168.1.0/24 UDPDHCPClient DHCPServer Any InboundThe DHCP server is connected to a Cisco...

Dear Gentlemen,1 - What is the Antenna which give me the same coverage of (2.2 dBi Dipole Antenna,2.4 GHz) Prod. # AIR-ANT 49412 - If i want to change the current antennas, should I make a new site survey3 - I need url for Multi floor Site Surve ?

I have an 1131 LAP that I originally configured with DHCP and it found the WLC fine. Then I forced the LAP to a static address from the WLC manager. Upon rebooting the LAP it could not find the WLC since it no longer uses DHCP and for some reason i...

Hi All,My customer has some Aironet 1200G which were upgraded from Aironet 1200b (by replacing the 11b module in the back panel of the AP). So I would like to ask could these upgraded 1200 be converted to LWAP by using the Cisco Upgrade Tools? Thanks...

Hello,I have a problem with Fallback configuration on AP 1240. In the manual 12.3(8)JA I found that there is possible to configure fallback wthen AP lost connection in RadioA, but when I go to int d0, there is only Reapeter and Shutdown, no Tracking ...

Hi,we have established a bridge connection between a 1310G Root Bridge and a 1310G Non Root Bridge with the following settings for this bridge SSID: "Open Authentication" with "WPA mandatory and WPA Preshared Key" in Client Authenticated Key Manageme...

When a client connects to the switch directly via ethernet we have no problems getting an IP. When connected to wirelessly we can not get a DHCP address, but if I set the IP to static, I then have no problems. Please note that the DHCP server being ...

I have just deployed a 4402 wireless controller and updated autonomous 1231 aironets to lightweight mode. All works ok.I create an interface on a vlan and added IP addresses etc.Whenever i attempt to associate a WLAN with the interface the only inter...

Dear All,I am seeing a strange issue with WLC 2106. Following is my setup :Catalyst 3750 <-> WLC 2106 <-> 1131 API have a physical port on 3750 configured as dot1q trunk. I have allowed all the VLANs. On 2106, I have the default interfaces configured...

Hello, I currently have 2 Access Points in the organization I am employed for I am supposed to maintain the WLAN infrastructure and secure it to the best of ability. We currently have a D-Link D1-714P+ and an aged Roam About, the D-Link using WPA TKI...

Hi,can you tell us please how we can get a Non Root AP (1310) to authenticate against ACS (Radius) ? We use WDS for CCKM and the Root AP as well as the Non Root AP have a username + pw defined on ACS but the Non Root AP doesn't get authenticated (it ...

hi friends,i configure my cisco 851w to connect by wireless but my adapter card can't detect my router.plz give me a simple configuration work 100%

Hi. Does anyone know when or if there is available a Vista driver for the Cisco Aironet Adapter, AIR-CB21AG-A-K9. I desperatly need to use this card and only have a vista laptop. My xp laptop died on me.Thanks!Becky

can anyone tell me what each of the following does Access Point RepeaterRoot Bridge Non-Root Bridge Workgroup Bridge Scanner many thanksCarl