Wireless

What do each of these interfaces do on the 526 WMAC? I am not sure I understand the functionality and did not find the answer to this in the documentation. Thanks

I recently purchased a 526 WMAC as well as 6 521 Controller Mode AP's for a Customer. These devices will be used in a Convention Center adjacent to the existing property.This convention Center will also be wired for about 80 cabled LAN drops. I have ...

I have a used AP and i tried to access through http to the AP Web configuration mode. My Configuration:ip http serverip http authentication aaaip http secure-serverip http port 801) I notice that i can only access through console? Why i cannot access...

Hi, I am looking to configure my Cisco Aironet AP without any VLANs and just one SSID.The AP will connect directly in to the back of a router on an interface with an IP of 10.20.20.1.If I set BVI1 on the AP to have an IP of 10.20.20.2, will this be e...

I have installed a 4402 WLC with 6 x Lightweight Access Points. I prepped the WAPs initially using the lwapp commands. The Controller found and registered the WAPs so no problem there; however, we unpluggged the WAPs from the 2960 POE switch and then...

Ever since upgrading my 4404 and WiSM controllers, I keep getting a bunch of MFP errors like the one below. Is anyone else seeing the same thing ? I have MFP set to optional. It is occurring in multiple cities.Thanks,Randy----------------------------...

Hi,Just want to check with you. Can we asked WLC to schedule down or up for the AP. For example, during office hour we will up the wireless. When the time is over, WLC will down the AP.

Is there anyway to change this limit?I have a great and easy to use system in place except that some of our contractors go beyond 30 days.This arbitrary limit is potentially going to screw the pooch on how useful this system perceived to be.Thanks.

Hi,How does the contain AP rouge really operates? I did contain certain rouge AP in the controller 4400, however the status mentioned about containment pending.Once the rouge AP being contain,is the controller block off the signal of it?Please advice

I didn't find any procedure to upgrade from bootloader. 1. Run primary image (version Not Found) 2. Run backup image (version Not Found) (active) 3. Manually update images 4. Change active boot image 5. Clear Configuration

Hi all,I have just been doing some reading from the Cisco web site and would like to summarise what I saw as the important factors in the documentation in reference to some basic guidelines to providing a successful VoWLAN deployment. This is the fir...

Hi,I have installed an AP 1250 , i would like to check whether the device will support 802.11 A ,G Series Adapter

I need to bridge a network segment with 2 VLANS across a medium range wireless link. Currently we have 1231Gs which can do this, however they seem to only support one VLAN in WGB mode.Is there any configuration in which the 1231G supports multiple VL...