Wireless

I am using 2 CISCO 4404 controller and 160 lightweight access point. In my network I have 2 6509 core switches 1 main and other backup with FSWM module. I have 11 floors in the site so I created 11 context as per customer requirement. Now the problem...

Hello everybody,We "inherited" an Aironet 1200 access point with antenna's throughout our building. This was installed by a company that thought they would make money selling Wi-Fi access but now they have gone bankrupt.We eliminated their router and...

Hi,Can any one guide me how can resolve this issue.The problem is when I power on I am getting the following promptap :Then when I press ? and then enter ,it lists out the commands.I have followed the factory default proceedure,but still I am not get...

HelloI have a wireless link via two BR352 with the latest VXWorks Software 12.05.I would like to monitor the bridge link traffic via SNMP to create graphs.I am not able to do that. I enable the SNMP in the bridges via the web interface, but the SNMP ...

I am installing an autonomous 1242AG/ AP and 7921s. I have a data vlan and a voice vlan. Devices within both vlans are not acquiring an ip address. 7921s are showing associated but with no ip address. Does anyone have a sample config that has a data ...

Anybody current using peer to peer blocking on guest/untrusted WLAN(s) while using 7920 21's on seperate voice WLAN? Most configuration/deployment guides state you shouldn't use this feature with voice deployed. Please correct/point me in the right d...

I always have configured the access points with only SSID and now and the port of the switch in mode access...I would like configure two ssid in my cisco access points ? I can do it ? In the switch the port must be configured as access port too?

Could anyone tell me if a pair of AP1410s will work if the remote antenna is obscured by trees? If so, what kind of signal loss should I expect? If not, can you point me to an alternative? The distance between APs will be about 3KM.

Hi,which is the differece between the SSID and the BSSID ?On my WIFI Bridge with "sh controller" command the output is:...Number of Supported simultaneous BSSID on Dot11Radio0: 8...is this also the limit of the maxium number of SSID ?If I need to con...

I have a 4404 controller with a Microsoft IAS server running radius. I can connect to the WLAN when I have no encryption. When I turn on WPA2 with AES and try to connect it fails. I ran the debug dot1x events enable and here is the output. There is o...

Hello, I have a few questions regarding the initial set up of the WISM in my 6509E. I'm using this as a guide:http://www.cisco.com/en/US/docs/wireless/technology/wism/technical/reference/appnote.html#wp69837This step: ! -- Create the vlan in the Supe...

Is there any template for wireless projects acceptance testing?ThanksJohn

Hi,I'm looking to combine three 54Mbps Wireless radios to increase wireless bandwidth, load balancing and redundancy. My intention was to create an etherchannel using the connected Cisco 2960 switch ports but I have read this is not a recommended sol...

Hi All,I am new to wireless and trying to determine what is the best authentication/encryption mechanism we can implement for our WLAN that does need WLC's. We have six 1242 AP's and an ACS. I want to be able to authenticate both laptops and phones a...