Wireless

How can i convert 1310 LAP to autonomous.

Hi, I am trying to resolve a condition where a wireless pc ( lxe vx5 industrial type machines - windows xp with sp2) connection to a foxpro application drops off at random intervals. Current wireless network card in the lxe vx5 industrial type machin...

I would like to force AP to the secondary controller without taking down the primary controller. It there a command that would accomplish this? I would like to move AP individually and not all at the same time. Thanks Chappy

Hi, I am developing an analytic model for the operation of 802.11b/g. Thus, I need some implementaion info. For 802.11b the specified basic rates-not data rate- are {1,2,5.5,11} Mbps; and for g they are {6,9,12,18,...,54} as I know. That is the thoer...

Hi expert My wireless network config for w2106 to serv for anonymous user in Guest lobby Mode. I want to know how to set w2106 for keep information clients detail in web management menu transfer on syslog service.

I have wireless setup consisting of WiSM and LAPs. Several WLANs are created, some with open authentication, some with web authentication and several with WPA/WPAs.I discover that all wireless clients, regardless of which WLANs they are connected to,...

We are implementing a number of WLCs at different sites that are connected by a WAN (site-to-site links). I'd like to use the WLC at site A as the backup WLC for site B and that at site B as the backup for site A.I've reviewed the documents that I ca...

Hi all,We may need 2 nos of Access Points and 3 to 5 nos of USB Network Adaptersfor Desktops. Please look at the requirements below. We would like to knowabout Cisco products which can meet these requirements.The purpose is to implement a automated t...

Hi,I have configured the below mentioned configuration for my Access Point. These wireless networks are not appearing in windows client network list. I have tried explicit scan also. Still it is not showing networks with 184,188 channels. But it is s...

Hi, I have configured the below mentioned configuration for my Access Point. These wireless networks are not appearing in windows client network list. I have tried explicit scan also. Still it is not showing networks with 184,188 channels. But it is ...

Is it possible to use PEAP-GTC without re-entering credentials after the client roams?Configuration is as followsRSA RADIUS, SecurID tokensWLC 2106 4.2, LAP1131Dell 630, Intel 3945abg, Windows XPJuniper Odyssey 4.52WPA TKIPCCKM enabled on the WLAN

Morning,I need a little direction as to where to go next in my implamentation. We have LWAPP AP's with Cisco WiSM controllers and WCS, I configured WPA-TLS auth and that works fine but when I try to tell ACS to make a Radius call to our RSA server, i...

We have a 1300 root bridge sitting on the outside of a building. I configured and installed a 1231 in another building adjacent to this building. The line of site is perfect. The 1300 can see the 1231, and has it in its association table as a WGB, ho...