Wireless

Hello peopleI tried to update my WLC 4402 from 4.1.185.0 to 5.0.148.0 and ran in to some trouble, this is what I did:1. Took backup of WLC (Commands -> Upload files -> uploaded config to a server)2. Shut down WLANS3. Downloaded AIR-WLC4400-K9-5-0-148...

Can advise if there are any good and important OIDs that we can snmp poll from WISM 5.0.148.0. Thks.

I want to setup a wireless bridge going from a current network (siteA), to a new small network across the street (siteB). I have 2 Cisco 1131AG Access points. I have no need for any client access, only the bridge. I have the interfaces up and can pin...

Hi,WCS: 5.0.56.2WLC: 5.0.148When I rollout an accesspoint template I always get the following error:Partial Failure:**ap parameters**Provision Failure: mediation-1, unspecified error,lrad,apPwd,Lrad![AP-Mac-adress]Most of the changes arrive at the ac...

Hi, is it possible to combine(connect) autonomous AP in WGB mode with LAP in HREAP mode? David

Hello everyone.First of all i want to say sorry for my bad english. But its kinda hard to get any basic materials in russian so im here..We decided to build Wnet in our ofice using Cisco devices...We bought point AIR-LAP1131AG-A-K9... and main my que...

hi,am trying to upload a customised web authentication page on to my wlc 4402.am using tftpd32 ver 3.23.the operation is failing,an i get the following error message on the tftp server.the file webathentiaction.tar is in the root directory of the tft...

I had setup a dev environment with a WLC and LWAPP AP, 1131G. The dev envioronment is gone and now I cannot reset my AP because the WLC it was associated with is gone. I have gone through all of the posts on this group to reset this thing and nothing...

We just took over a site that has the 350 Series Ap's in place. I need to get into the AP and change the username and password... or at least set it back to default without killing the whole config.

Hi All,Intro:We have a small client demo in which we have the 1231 AP with PEAP authentication and WPA (TKIP). The ACS server is placed in another country. The number of clients are not more than 5 as for demo and the environment is indoor. Also ther...

We recently had a project where we were going to create 4 different wireless networks across the country and use 4400 controllers at each site. We had the controllers payed for, along with all the 1242, and 1510 APs. Then we ran into a speed bump wit...