Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi,I have a problem with my wireless network were the client can connect using WEP to the AP's but they are not being assigned an ip Address from the DHCP pool on the core switch. I have looked in the logs on the eight AP's and cannot see any errors ...

Is there a way to stop the WLC advertising all the configured WLANS (SSID's) on every LWAPP AP? We have a WLC controlling several LAPs at different sites, but i only want the WLAN SSID's that are relevant to each site to be advertised on that AP. I k...

c.walsh by • Level 5
  • 850 Views
  • 2 replies
  • 0 Helpful votes

Hi, I am trying to enable POE on our three new Aironet 1130ag but they fail to get the power from 6500 switches which have WS-X6348 modules and WS-F6K-VPWR sub modules. I disabled power injector and tried power negotiation and pre-standard compatibil...

rmirian by • Community Member
  • 1383 Views
  • 1 replies
  • 0 Helpful votes

Hi guys,in your opinion what should happen if i use 7921 and AP with 12.3(7)JA.(i.e they register but don't work fine or they don't register at all)thx.......

Hello.Has anyone used a 1522 AP?If so has anyone tried an SFP module other then a 100BX-U and 100BX-D.Just curious.

timkaye by • Level 5
  • 1077 Views
  • 2 replies
  • 0 Helpful votes

The application is to provide wireless in three conference rooms, rooms are 20' x 50', on three floors, each conference rooms is stacked nearly on top of each other. Total concurrent connections to any one point <30. Total concurrent connects to the ...

Just saw that WLC 5.0.148.0 release notes were posted today.http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn501480.htmlLooks like some very important updates. Can't wait for the software to go live.

Hi,I am trying to configure a pair of Aironet AP1231G as a wireless bridge.Both ap's are loaded with software ver 12.3(8)JEC.As I am using external antennas I need to select the primary antenna port for both Tx & Rx.This option is listed on the web i...

briancobb01 by • Community Member
  • 3972 Views
  • 5 replies
  • 0 Helpful votes

I just purchased a 7971G phone and I tried updating the firmware to 1.1.1 using a USB connection since I cannot connect to my wireless network since it is using PEAP.I was unable to determine the current firmware so I logged into the device's website...

maloyal by • Level 3
  • 2318 Views
  • 6 replies
  • 0 Helpful votes

HI, I am trying to implement Local EAP (EAP-FAST) authentication method on WLC 4402 with LDAP as back end database as we dont have ACS in our network. We are running Wireless Software version 4.2. We are unable to do so. I need configuration assistan...

Review Cisco Networking for a $25 gift card