Wireless

I'm having a problem configuring WPA2 on a Cisco 1231 Access Point, where I see a command which I cannot do on this one, which I could do on 1240 AP's. On the 1240 I've the following config of the SSID: vlan 60 authentication open eap eap_methods aut...

Hi Guys, I have an issue in a High School with some clients having issues authenticating using LEAP to AP1100 802.11g, I am pretty sure its the build of the client but I am unsure about the signal strenght & quality, most of the clients sit between -...

greetings.We have three 1232AG APs configured as two root bridges and a mobile work group bridge, designed to give coverage to the work group bridge as it moves across the campus.We are experiencing the situation where the workgroup bridge is relucta...

I have a 1130 AP connected to a 500 series express catalyst switch. I want to have two vlans one for guest internet access only and the other that can have both internet and internal access. I want to have two SSID one for guest and the other for int...

i put wrong firmware, then that led light say ethn: green status: flashing green radio: 1 time red flash and 2nd time red flash every time. what i do with my AP?

Hi.I've a 4402 controller configured. Ready for use.I've three 1242AG LWAPP which are able to associate to the WLAN controller.My issue is, I cannot get an IP via DHCP for clients requiring 802.1x authentication.For an open SSID with no authenticatio...

I need to configure the router to give me the best coverage possible what is the best approach to do that? 802.11b speed is more than enough but my router has only A and G.Thank you

At Site-A where the WLC4200 & DHCP server reside, we have the following subnets:- (vlan10) 10.10.10.0- (vlan11) 10.10.11.0Each VLAN corresponds to a dynamic interface on the WLC ("Int-10" & "Int-11") which is assigned to their own respective WLAN. Wo...

I am trying trouble upgrading 3 1242AG. There are no images on them. I have tried using tftp and ftp to upgrade. Any tips or Suggestions thanks

Hi all,I'm connected to autonomous 1230 AP via serial cable. The issue is that the firmware is wrong for that type of AP. When it has downloaded the wrong IOS, it boot immediately, so the loading process is in forever loop. How I can interrupt the IO...

Hi, folks.I have to set up some VLANS on Cisco 1240 access points. I have a linksys SRW248G4 Switch. I have set VLAN1, as native on the AP, the same as the switch, and added VLAN10 and VLAN20, and associated an SSID with each, The radio interface is ...

Hi,We're having problems with our 1240 LAP when converting to Root AP as its AP mode. We're encountering the problem when we set its AP mode to "bridge" mode. Once we have set it to bridge mode and click "Apply", the WLC prompts that the LAP will reb...

I am going to be configuring a 3750g-24WS and after reading the documentation I have a question on the creation of a WLAN dynamic interface and the need for a concurrent VLAN interface on the switch itself. When a WLAN is created a dynamic interface ...

If i have one wireless access controller with 8 LWAPP.Suppouse the wireless access controller fail (hardware fail).What happen with the lwapp ap's during the fail.How log will work the lwapp ap's without the WLC.What happen if the lwapp ap's are powe...

I'm using a blade as a controller in a cisco router. trouble is it does not see the 1131 access-points. does see 1020 access points. Any thoughts