Wireless

Hi,I got a trange issue.On ap1242, if i configure mobility network-id on the SSID manager, I cannont anymore associate with clients.On 1231, with the same configuration, all works fine.Anyone had similar issue ? I tryed ( on 1242 ) to add and remove ...

I am trying to use Chillispot (www.chillispot.org) to set up a guest SSID on the AP1200 in our boardroom.The AP is configured with with a private SSID and a public SSID. Each of the two SSID's are assigned to a unique Vlan. The access point itself, s...

We are exploring implementing a wireless lan controller to centrally manage our existing AP's and we already have a 3750 switch but when I enter in to the Cisco Device Manager there is no option for the Wireless Controller Settings. Is the Integrated...

Hi,I was running ACS3.0 and I upgraded to 4.0 now The access points or clients cannot authenticate. Does anyone had similar problems?Thanks in advance.Biju

I have 3 1131AG access points that i am setting up in my office building. I would like to setup each ap in such a way that if a user is connected wirelessly that can "roam" throughout the building, and if they get dropped off, once they are in range ...

I have 3 1130AG set up in a school for student laptops. The problem is laptops can connect to one ap and not the others, however when the laptops are connected to the first ap the laptop will connect to the other ap's when the laptop is placed near t...

Dear All, when I set up a new Aironet AP (1242 or 1310) there is a section AP Authentication (below Security). Can anyone explain me how the AP Authentication works and which device authenticates the APs ? Can this be done by the local authentication...

Hi!I have a network consisting of 22 autonomous Aironet 1120G accesspoints. Is it possible to upgarde these to lightweight accesspoints for using with a Cisco WLAN Controller?

Hello all,i have bit confusion, Linksys Access Point comes at which layer of TCP/IP....Thanks,Dhaval Tandel

We currently use the Intel 2915ABG cards but would like to replace them with something that supports CCX without the Intel PROset software. I know that the Atheros cards support CCX3, but we are looking for something that supports CCX4 with only the ...

I have a customer who keeps drilling us on going entirely wireless. While we keep talking about shared RF spectrum, shared bandwidth, etc they remain unconvinced.Can anyone point me at information on Cisco.com that talks about this?

Hi,Sorry if this is a daft question or in the wrong forum but I am pulling my hair out with this one. According to the spec the 857w router does support WPA2 but I can't for the life of me get it to show up in the configs anywhere. If it does support...