Wireless

I have experience with cisco wlan products, but no experience with Aruba Networks. Could someone please point out a few advantages of Cisco over Aruba Networks' offerings?I am trying to justify the higher initial cost of Cisco equipment to a client.

i have many building i need to cover it indoor wireless but in the other hand for mobility roaming i need to cover the outside area i will use unified system (LWAP) I need some recommendation about kind of access point and how to avoid any interferen...

Hi all,is it possible to do machine authentication with following setup?-Workstations with Windows 2000 SP4+latest updates-Cisco Aironet 1242AG Access points-RADIUS (=IAS in Windows 2000 Server)-Windows 2000 domain with CertServices-3com 3CRDAG675 A/...

We are trying to set-up the WLC4402 (with the latest 4.1 code) on our network. We have the ap-manager and management interface assigned to port 1 (on VLAN 10), which connects to the main network. We'd like to connect the wireless users (on the same V...

I have nortel branded spectralink phones that continue to get a watchdog timeout message. Voice quality and wireless coverage seem to be ok. But I keep getting hostflapping messages in the 4507 and all the messages are related to the mac addresses of...

Hi All, i have 2 4400 Controllers to integrate. Both are connected via LAG, Switchconfig config follows the Deployment Guide. with no dynamic Interface configured, everything works fine. With the first dynamic Interface i configured, my trouble began...

Hi,The Windows Status window on XP Prof. says data rate 54M (.11g).When I'm not transfering data to or from the wireless client roaming behaviour, when client is not physically moving, is stable, predictable and intuitive.I'm testing FTP GET and PUT ...

Hi,1) If a wireless client can see AP "A", to which it is associated, at -40dBm and AP "B" on the same Chan. at -70dBm, is "B" seen as co-channel interference by the client and so CCA (Clear Channel Assessment) concludes that the chan. is not free fo...

hi all ,i have aps 1242 with wireless client associated and an ap1242 in workgroup bridge mode associated too , can the ap in workgrp mode roam between different AP1242 ? if yes is there some special conf needed ?normaly the client decide wich ap to ...

My friend has a house which has a guest house about 300 yards down in a hill. I tried even the best Linksys products but had no luck. So thinking about using some high end Cisco Wireless solutions. Does anybody have any suggestions? I would really ap...

Hello All, I'm hoping that someone here on the forum can help me with a possible solution.I have a small network with a Cisco 1200 AP. Is it possible 2 have 2 SSID's on the AP? One for guests and one for internal LAN users?My thought was to create 2 ...

I have a BBSM 5.3 that is configured to authenticate users via an RSA RADIUS Server and uses the transparent proxy setting which is all working. I was looking at the ISA Server logs and noted that all the log entries were using anon as the user, is i...

PLS I WANT TO KNOW ALL THE RADIO STANDARD FOR WIRELESS LAN CONNECTION

We have a WLAN Controller 4402, with firmware version 4.0.206.0. The ports are connected to 2 separate switches. 'ap-manager' is on port 1, and 'ap-manager 2' is on port 2. The wireless network is running fine when both ports are connected. However, ...

I have a 1231 WAP that I just continually reboots. Here is the error it gives right as it reboots: %SYS-5-RELOAD: Reload requested by LWAPP CLIENT. Reload Reason: FAILED CRYPTO INIT.I may have put the wrong image on it, I didn't want it to be in ligh...