Wireless

I'm trying to find configuration guides and resources to build up a wireless authentication solution using certs. Currently we have a few wireless controllers and thin AP's. However, on TAC configuration guides, I'm only able to find SSL certificate ...

Hi,I would like to know whether WCL 4400 Series support AP 1000 Series? By referring to the Q@A on AP 1000 Series, the statement below clearly stated,Q. Which wireless LAN controllers support 1000 Series lightweight access points?A. Cisco Systems cur...

Hi all,I have a cisco 1231 AP that has 2 SSIDs/VLANS on it.I am trying to test and even with my laptop with wireless card 2 feet away from the AP, it never trys to associate it.1 vlan is PSKOther vlan is Radius WPAI have been debuging radius and dont...

Please excuse the basic question. I am trying to figure out if the AP 1231G can be used at home.This is the setup. A housing complex with CAT 5 in all appartments. User just plugs a PC to the wall and gets DHCP from provider.I need to plug the AP str...

Hi all, I got several VPN gateways(servers) behind my WLC 4402. I need configure their IP addresses in WLAN Layer3 security section VPN passthrough. But WLC permit to enter only one IP address of VPN gateway. What to do? Thanks for your answers

We have 10 Cisco 1200 wireless APs. The VLAN 1 use Windows certificate as authentication and VLAN 100 for the public. They work fine. We just bought two 1310 wireless bridges for outdoor use. We contact Cisco support for setup these two bridges. The ...

Is it possible to get the bandwidth data for each client that is connected to the AP using the Cisco MIB for the Aironet 1131AG? I have found it is possible to obtain the signal strength and connected client's MAC address.In addition does anyone know...

I can't seem to find any reference to the 7920 phones supporting PEAP, and I don't see an option to configure it on the 7920 so I guess the 7920 doesn't support PEAP right?I have WCS, and 4402 controllers with 1242G AP's setup, and setup to only use ...

problem solved.

Hi all, I have a problem with two Ip Phones 7920.I have eight Access Point 1230G with the same configuratione and the same Ios version (123-8.JEA1)When I power On Ip Phone 7920 under Access Point 1 ,It take address from Dhcp with correct registration...

We are using CB21AG(ADU3.0) and AP1131AG. The problem is ping delay happen periodicaly,ping destination is gateway and WLAN client to AP IP address. There is no radio interfernce and clean RF circumstance.We have four CB21AG having same issue but int...

hi, i have a problem, is there any1 here ever encountered some users cannot associate to the same ap in the environment but some users can ?

Problem: Two people working on the same WCS created the same building with different names. One building has two floors and the other has two floors. Rather then delete and start over is there a way to move a floor to a different building? Or is dele...

I recently installed a new WiSM bundle and converted a group of Autonomous APs to LWAPP and now CiscoWorks does not see the APs. Any thoughts on this would be appreciated.

Can some body explain how the pre-authentication works? Let us I am connected to AP1 using Static WEP encryption. At the same time I see AP2(its signal strength is weak compared to AP1) to facilitate roaming. Will my laptop send authentication reques...