Wireless

We will be installing a 4400 series WLAN controller at our central site, but have several remote sites that we would like to place lightweight access points at. From what I have been reading this can be done using REAP, but is only supported on sever...

Hi, I have a 4402 currently configured, 1 interface goes to 1 6500 and the other interface going to another 6500. LAG is disabled. The 2 6500's are connected via a L2 Etherchannel.Currently, spanning-tree is disabled on the WLC and it appears to work...

Hello,i'm having issues with my AP. It was mistakenly changed to DHCP from static, and unfortunately, there is no DHCP server running. I dont know how to access the GUI so as to statically configure the IP address. The setback i have is, the AP doesn...

I've got 4 1130ag's, three at one site and one at another.I get just about 2Mbps over them. I've limited the AP's to only use G speeds per Cisco's docs, I've verified the ethernet port on the 3560's they plug into, they transfer at real 100Mbps Lan s...

Hi,We have a number of Nokia E series phones that we're trying to get to work with a 1231 access point for SIP. On occasions it will associate but generally when we try to join the phone to the SSID it will crash and reboot. The AP is running c1200-k...

Anyone seen this? have had it happen once on 3 different controllers. After it happened recently on 1st WiSM WLC, APs joined the first WiSM WLC in their Mobility Group list (mWar list), until this controller had the same issue. APs did not appear to ...

I installed a adapter in my laptop. When I tried to use it at home with a wireless router, it found the channel however "not assiciated". How can I manually associate it? Is it supposed to do it automatically?ThanksGary

Does the WLC and LWAP supports multiple VLANs on a single SSID, in other words, could I configure the WLC and the LWAP in a way so that I can join any VLAN in the network based on the authentication 802.1x

WLC 4112 bootloader image is crashed.How can i get bootloader file and RTOS.The primary and secondary images are corrupted and cannot bootable now.

Dear all,I convert 1231g to lwapp.When I console the AP, I get this message "*Mar 1 00:00:23.535: %LWAPP−5−CHANGED: LWAPP changed state to DISCOVERY*Mar 1 00:00:23.550: LWAPP_CLIENT_ERROR_DEBUG: lwapp_crypto_init_ssc_keys_and_certs no certs in the SS...

Hi Guys,I have to following:4400 Series WLCCat 3560 PoE-241 LAP1242AGOut of the distribution port 1 on the WLC, I have it plugged into the Ge0/1 Cat 3560. Everything is on the same Vlan. My AP is plugged into the Cat and is able to obtain an IP addre...

We have two wireless devices both with two radios installed. Dot11Radio1 is used for our bridge and the other radio is used for wireless users. My problem is that I have two VLANS, vlan 100 is for data traffic and mgmt traffic, and vlan 200 is for my...