Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
What is the default mode for AP1131AG,Autonomous or Lightweight Mode.I am using WLAN controller 4402.Thanks
I have read many online documents about 802.11x, all that i found they named port-level authentication.It makes sense for a wired network, since we have got a physical port, then if the supplicant has been authenticated, his port will be open to tran...
i cannot install my pcmcia wireless driver under xp pro vmare , the instal wizard asks me to instal the pcmcia cardthe physical machine is win 2000 pro and all works fine on itcan u please help meregards
Would someone be kind enough to share a sanitized config with me for the following:AIR-LAP1131AG-A-K9 LWAP converted to autonomous mode running IOS v12.3(8)JEAWPAv2 with PEAPv0 aka EAP-MSCHAPv2.Thanks,Richard
Does anyone know what impact changing an AP hostname would have on underlying platforms or apps? I'm asking because I know that a cert is generated during conversion from heavy to light weight but I don't think the hostname is embedded anywhere in th...
Can anyone provide assistance with loading a pre-existing CA Certificate on the WLC4400 ?
We are running WPAv2 for our CE Symbol handhelds (MC9060). We also run a Spectralink VoIP system at our retail stores. We disabled WMM over the weekend per a Spectralink recommendation and found immediately afterwards our WPA handhelds could not auth...
We have a bunch of old 3524XL's that are providing power for our Autonoumous AP's.Does anyone know if they'll work after we convert the AP's to LightWeight?thanks.
I was under the impression that the Aironet 1100 supports 802.3af POE. I purchased a NetGear FS108P POE switch, however, when I plug in the 1100, it does not receive any power.I have seen references in the documentation to a Cisco inline power inject...
Hi,Please tell me what the shortest time is between RRM changes (eg. Channel change or Tx. Power level change) with default timer values, assuming RF conditions would have a change made necessary.I think it's 10 minutes but not sure.Anyone know emper...
Hi forum,Can wireless clients roam seamlessly between 802.11a and 802.11g APs? they will be using the same SSID.besides, if I select different channel for bluetooth clients, can it coexist with 802.11g? Thank you,paul
I have a AIR-AP1242AG-A-K9When I connect my console cable to the Access point it puts me direclty into ap1.ciscow>versus the username prompt.I dont have the command 'login local' or 'login' like a switch or router does for vty/con/aux lines so just t...
We have some non Cisco AP's that I am trying to configure a Cisco AP 1240 to associate with. The radio will not come out of "disabled" Antenna is connected and I have done the basic config, there is no security set up at all on the existing untit. Wh...
I converted an AP 1121g to Lwapp sucessfully (so it seems) using the Lwapp conversion tool. Once rebooted the WCS only sees the AP sporadically and then the AP drops from view only to show up again with a different AP ID. When it does show I can atte...
I have been given the task of setting up the Security for the WLAN, the system has been up and running for a few years and now with everyone running around with Lap tops we need to limit the user that can get on to the network. So I need some info to...
