Wireless

Hi,I have the following scenario:2 x WLC 4404'sMicrosoft IAS servers at HQ and one per branch (6 branches)AP1130'sThe challenge is that the company wants to make use of one SSID for staff members at all the locations, but the authentication takes pla...

Folks - just coming in on the tail end of a project where a wireless solution is in the process of being implemented. Quick question for anyone who may be able to assess. Quick overview - a 4 floor hotel where from the mid-point of each floor, the di...

I'm having a problem with a Cisco Aironet 350 WiFi PCMCIA Card (speed has to be auto) installed in a Sony Camera and intermittently not connecting to a ZyXEL ZyAIR G-110 WiFi PCMCIA Card (speed set to b only (which is 11 MBPS))which is installed in a...

Hi,I hope someone can help.I have successfully setup a small wireless network for a friend using a Cisco 857W. Everything works fine except that by default, the router appears not to allow communication between authenticated wireless devices.I have d...

I just purchased this WLAN multi-client adapter and need some help with the configuration. I accessed the settings page via web browser and clicked the selection to restore default settings, and now I cannot access it at all.I am a Macintosh user and...

HI,I Have problems with AP authentication on the WLC. AP gets the IP from the DHCP but fails to load the image.On the WLC log I get:Sun Sep 3 21:49:51 2006 [ERROR] spam_lrad.c 2544: Security processing of Image Data failed from AP 00:17:59:67:76:80Su...

I have installed an Aironet 1242 in my house and I'm having a few issues. I have noticed that my signal-to-noise ratio is the same as my signal strength. The stronger my signal is my signal-to-noise ratio rises also. Not sure if it is related by I?m ...

Anyone have a good working 1200 AP config that I can take a look at? Im trying to do this CLI because the GUI, to me, bounces all over the place and Id prefer to go at it the CLI way. Id like to see a config that has VLANs and QoS if anyone wouldnt m...

We use WISM Web authentication. When clients shutdown/standby computer without properly "log off" from the logoff page, where do you define the idle timer to log out client in this case? I tried the "User Idle Timeout" and "ARP Timeout" parameters in...

HiDoes someone know if i can save the configuration from a 4402 controller and load it into a 4404 controller? Does this work?regards Dave

hello all,why i can't ping to ap-manager interface on WLC? actually, i can't ping to ap-manager intercae on WLC ver2.2(airespace version)Regards,John.

Hi Sir,I have a lightweight AP1010 that I set up to join a WLC in L3 LWAPP mode. I have configured a static IP address for the AP, and set its primary and secondary controller. It works fine for quite some time.Lately, the AP has problem joining the ...