Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
I have Symbol handhelds with B radios which up until 12.3(8)JA used to associate and authenticate fine. We isolated the problem in 12.3(8)JA to the AP's having 1 and 2 Mbit rates disabled, once these were enabled all is fine again.Anybody know what c...
The documentation for the 1130 access points indicates that it can support 108 Mbps.In order to do this do I need a single AP with two 11g radios. Or can it be done with two 1130 AP each with an 11G radio.
I am having quite a bit of trouble with setting up a very simple network.My objective is to cover a small warehouse with wireless coverage to allow for data collection from remote scales in fixed location.To reach to the far corner of the warehouse I...
Hello together,is there a way to prioritize voice traffic over a bridged wireless connection? Currently we use two 1310 bridges in a flat configuration (no vlans, psk, ...).Thanks for inspirationsAlex
Greetings All I know that the Native VLAN in a switch is VLAN 1Since my access points needs a native vlan to perform multiple SSID and VLANS etc. If the ACcess pont is sitting on VLAN 20 with an ip address assinged to it from that vlan does that mean...
I want to know the nature of WLES (hard or soft), and where I can download it?Thank you
Is it possible to have a stateful redundant pair of pixes without using the serial cable? Or is it the case that some aspects of failover can not live without the serial connection between the two members of the pair? Thanks.
How many MAC address filters that can be configured on the cisco 2006 wireless controller database?Is it 100?
When a BR1310 is in Workgroup bridge mode, it can provide a wired connection from the BR to a device. Can it also service wireless users?
Hi all.Does the Cisco Network Assistant manage the AP1131AG? Thanks ...
Hi all!We created two VLANs namely VLAN1 (on Dot11Radio 0.1 and Fastethernet0.1 which is native VLAN)and VLAN2 (on Dot11Radio 0.2). We gave ip addresses on Dot11radio0.2 and Fastethernet 0.1 which are in different subnets. We can not reach the Dot11r...
Help - I have assigned an IP to eth1 which I would now like to change. Unfortunately nothing happens when I issue the command. It does not even respond to the 'interface eth1 down' command. I am running WLSE 2.13. I've reloaded several times with no ...
I admit I don't completely understand mobility groups. I need to add a server on one of the wireless networks. I can't seem to figure out if there is a way to configure a port on a 6509 to be in the same wireless mobility group. Thanks.Edited: No nee...
Hi,we have got two ofices in different area. We decided to connect them with two AP's Aironet 1310 with mode point-to-point bridge. We have voice traffic over this wi-fi channel. If we use IOS 12.3(4)-JA we have noticed many errors in the logs 1310 s...
I had 6 LWAPP AP's confgiured with primary and secondary controllers. I shut down primary controller - 5 AP's swapped over to secondary controller - 1 couldnt join. Turned primary back up and the 5 moved back and the 1 LWAPP AP still couldn't join. I...
