Wireless

Hello,I have what I think is a very basic question about the WLAN Controllers yet I can't seem to find the answer in the manuals.The "thick" Cisco APs act as L2 bridges. They forward frames at L2. How do the Controllers work? Are end user packets tun...

I am having problems upgrading two 1200 APs from Cisco 1200 Series AP 12.03T VxWorks to IOS using the CAC Tool. Originally all eight of my units were at Cisco 1200 Series AP 12.02T and I successfully upgraded six of them to IOS, but these two have be...

Hi all.I have an AP with IOS 13.2(7) - Cisco 1200 Series IOS WIRELESS LAN LWAPP. I can not enter the global configuration mode. any idea? I also can not access to the web mode of this AP (I have checked that it have assigned a IP address) ??Please ad...

Need assistance in understanding debug output. Wireless AP are failing authentication through ACS. Difficulty is a separate group manages ACS and I do not have access to see corresponding error log. ACS group indicates it is a LEAP error and possibly...

We have our WLSE taking Inventory of our Access points every 2 hours. The total of our Access points is 168 and we have 26 WDS per every subnet. Does that effect our end users….?

Can any one help me to determin what the TX watts, RX watts, and standby-power consumption is on 1200 AP. I'm trying to determin this information to see how big of a battery I need to power one AP, and how long that battery well power the AP for.

Can someone tell me the meaning of this message on a 1300 brige?%DOT11-4-CANT_ASSOC: Interface Dot11Radio0, cannot associate: no wpa-v1 v2 chk neededI am not running WPA on either bridge so I am not sure what this means.

Can anyone please explain what Energy Detect Defers means or point me to a link that does? This is under the Radio Interface detailed status. We are also getting a lot of retry erros on this interface. Throughput is suffering. Any help would be appre...

We have setup two set of bridge to interconnect our network for resilience design. Two pairs of 1400 bridges were connected to our switch, we found problem on the failover that the Ethernet connection to bridge is always up(active) even the pair of b...

Hi, I have a simple issue. I have one building about 50 feet away from a building that has wired access. I'd like to beam wireless access from the wired building to the other building that is ~50 feet away. What two pieces of CISCO Areonet equipment ...

Hi,I want to upgrade two Aironet 350's - I'm assuming I can use the firmware / IOS downloaded from "Aironet 350 access point" rather than "Aironet 350 bridge" (which has no IOS updates on) since the 350 can act as either? The version is c350-k9w7-mx....

Hello,I have a setup with a brandnew 2600 WLC and a AP AIR-LAP1242AG . The AP seems to find the WLC's Management ip address via DHCP option 43 but in the logfile shows the following problem with certificates:Tue Feb 28 16:48:55 2006 [ERROR] spam_lrad...

I want to use Cisco VMS to manage my IPS and firewalls.A also have two routere and five switches in place can i use the same software to monitor and manage them or I need separate software.

I have multiple ap's in a library, all settings left to defualts(mostly) POE, primary antenna only, random clients lose connection and cannot see ap and have to be re-added by local admin before they will see ap again. any suggestion??more info??