Wireless

I have a Cisco 871W, config attached, with connected LAN desktops and WLAN laptops and 1 WLAN printer. The desktops have no issue sending print jobs to the printer but I'm unable to do so with the laptops. I can ping LAN to WLAN but I'm unable to pin...

Hi all,I have been trying and trying to get the WPA with a cipher TKIP to work. This config is pretty much straight of a Cisco example. I always get an authernication failed error. Here is the whole config, if anyone has any idea of what I did wrong ...

I want to use the remote site router cisco 3845 as a radius server, it already runs WLCCP WDS for the APs, I cannot get it to work, but putting the configuration on one of the APs, the AP works ok as a radius local-server. There must be some differen...

I am trying to install an AP1131-AG, I want my wireless clients to connect to it using certificate authentication via a RADIUS server. I am running an Enterprise CA (Windows 2003 Enterprise), with the SCEP add-on. I am not using the internal RADIUS s...

This is how our setup is like:Laptops => Cisco 1100 AP(static IP) => Wired LAN (Subnet 1) => Cisco Router => Wired LAN (Subnet 2) => DHCP serverWhat i would like is that the DHCP-request from our laptops is forwarded/relayed through the AP and Router...

I need a way to compare the configs of Cisco 1200 series IOS APs. Some of my global sites need to verify that their APs are properly configured, but they don't have a WLSE. So I'd like to provide them with a config file, and have them compare their o...

Hello are there any important limitations or issues to use with cisco a/b/g Card the authentication methodes LEAP or EAP-FAST.Any input is welcomeOliver

I currenlty 1220 AP Point. The thing was working fine but when I rebooted the access point I can't access the web interface. I can console into the AP and do everything that I need to but it's helpful to have the Web Interface up. When I try and go t...

I like to AP's admin authentication by RADIUS. The authentication is ok by console connection. but telnet or http authentication is fail cause limiting level_15_access. Is there any misconfiguration? Check this out please.Thaks **********************...

Running IOS version 12.3(7)JA1 on AP1200 b/g, after turning off CDP on AP. AP failed to initiate power from the none Cisco POE switch. Please advice.

Going about 1/2 mile. What would be the best antenna for the price

I've got big problem with one of my access point, when I was trying to make software update it had stoped working. No leds are:1 - is red2 - is green3 - is redWhat can I do with that. I can't comuniacte with AP so I can'd do anything. I was trying re...

I'm looking for a device to (securely) connect two buildings together that are across the street from one another. The distance is 500 feet at most, and there is a direct line of site. It would cost too much to tunnel under the street, so I'm looking...

Is it possible to update AIR-BR350-E-K9 Bridges to Cisco IOS Software 12.3(7)JA2 ?At the time version VXWorks is installed. At realease Notes there are a upgrade procedure - (migrate process). Our reseller tells me there is no way to upgrade a AIR-BR...