Wireless

Hi,I have Cisco 1240 and 1130 APs with Intel Proset clients using the latest drivers, and I can't get EAP-FAST to work. All of my APs have 12.3(7)JA. My Odyssey clients work with EAP-FAST but my Intel's won't work. I keep getting asked to accept the ...

Hello everybody. I have a 1300 bridge pointing at a 1200 Cisco AP. Ther are no vlans set so I did not set the bridge as an Infrastucture client. The wep, ssid's, same subnet addresses, channels are all good and properly configured. The thing that get...

Dear NetPro,i've configured the ACS server(Primary)and replicate to ACS server(secondary). but, it seems the secondary didnt received all update from primary server. does anyone encountered this before ? your reply will be highly appreciated.Regards,...

Okay guys...lend me your expertise here. Essentially I'm just trying to get a 350 to function as a repeater for my DI-624. I've gone through and done everything 3 times. Made sure the communications standards and settings are the same. Added the corr...

We are currently running WEP on our wireless network and we want to change to WPA using PEAP. With WPA/Peap I've been reading that you need a radius server which we have already setup, but I've also been reading that you need a cert at the IAS server...

When can we expect a similar ACAT tool for the ABG cards? i.e CB21AG?

Hi,I am planning to upgrade from my existing 350 AP to 1240 AP and has setup a 1240 for testing. While testing, I found out that centrino laptops takes a longer time to associate with the AP then laptops with cisco B cards. The Centrino laptops would...

I have a 350 bridge installed with a 100 ft antenna cable. I need to move the bridge, because of an alignment problem. To move it I will need to use an antenna cable longer than 100 ft, so if I can use a longer cable what is my signal loss? Does Cisc...

Is ther any quick tip on how to configure 2 1200 AP's as bridges with high security.The AP's are supposed to be an extension to the existing LAN and not supposed to handle any wireless clients.Any response will be helpfull.

I just want to confirm something.From everything I've read on Cisco products there is not a Wireless bridge and anntena configuration that will allow me to set up a non-line of site bridge between two locations.Correct?I have a customer who has two l...

Hello allWe recently installed some new Cisco Catalyst 3560 that have some Cisco AP 1100 connected. Unfortunately, the WLSE logs all our c3560 as "unsupported device" in the discovery logs.This page claims they are supported:http://www.cisco.com/en/U...

hiany one know about wireless (aironet ,350...) simulator

Can someone tell me what channels to set inorder to avoid distortion when you have multiple floors. I know that channels 1, 6 and 11 are recommended for single floors but what do you apply for multiple floors ?

hi is there any Cisco AP's with 100 mbps or 108 mbp's Rf throughput.please reply.RegdsBinoy