Wireless

I have AP1100 w/12.3(2)JA2.I have Air352 with new firmware and drivers on a XP, SP2 computer.I run WPA w/PSKAfter running well for 30min to 2 hours, we just lose the association for the PCs, one by one, at different times. We can reassociate by re-se...

I am using 1200 as a WDS. There are about 30 APs connecting to this WDS. I am having a problem these days to authenticate users. When I reload the WDS, then users can connect. But after some time, the same porblem starts again which is User Athentica...

i'm trying to upgrade from version 11.54 to the newest version available and can't seem to find the correct documentation from such an old version to the newest one. 11.54 has a completely different layout than v12. The only problem is, is that i can...

I am having an issue that I can't figure out why it is occurring. I have a wrt54g and on my WAN port I have an external address and on the same wrt45g, I have an external address on the LAN port.I am connecting wirelessly through a wet54g bridge with...

Hello,I configure a WLSE with AP 1200 series. In the main site there is no problem, all AP are discovered by the the WLSE.On distant site (connect by VPN to the main site), AP are configured tu use a WDS. This one, is configured to use a WNM (the WLS...

I have a building approximately 150-200m away from my main site, which I have connected to our LAN via non-Cisco 802.11b wireless bridges. My company is located in the city and we are aware of atleast 20 other wireless networks in close proximity. Ev...

I am not having a successful time getting Linux to use the 350 MiniPCI internal card in my Dell Latitude D810, using LEAP for our network.I have tried downloading the linux drivers but that seems to be a dead end. I can't even get the install script ...

I upgraded an AP 1100 and AP 1200 to IOS 12.3(4). I am associating to the AP 1100 and the AP 1200 is acting as a dedicated WDS server which forwards authentication requests to a RADIUS server. I succesfully used LEAP and EAP-FAST authentication with ...

Hi all,Can anyone tell me if and when they would use Hot Standby Mode to provide a redundant wireless solution. What would be the problem with a second AP on a non-overlapping channel for an isolated WLAN island, or, a large overlap design where grea...

Hi,I have a couple of problems with the trend reporting in WLSE. I've selected the RF and Ethernet utilisation graph, but when I click on weekly reports it comes up with available dates from 01/13/2005 to 04/14/2005. I can't work out what's happened ...

Hi,I have enabled the AP 1200's SNMP. Understand that signal strength can be extract from awcVx-MIBs. However, I m unable to display anything. Is there any prerequisites or steps to be taken ? Appreciate any answer...Thanks in advance.rgdsFrank

I am having problems setting up WDS... on my 1200s I am getting events stating the the "AP has timed out authenticating to WDS". Also, under wireless services my wlse server is showing a status of unauthenticated. Any ideas? Are there any good docs o...

I am using Cisco 1100 series AP with PEAP authentication and IAS. I have debugged a long authentication\re-association problem down to the AP rejecting any session key length which is greater than 32! The IAS server attempts to issue session key leng...

Dear friends,I'm configuring a link between two 1310, one using a Yagi and the other using a omni. The configuration is pretty simple, without any type of special feature, like cryptography. When the bridges are near one of each other, the link is pe...