Wireless

We surveyed a property last year with "B" radios and now we are deploying "G" radios. Will there be any coverage change? Should we re-survey the site?

Need explanation if this is good or bad from a cisco AIR-AP1231G-A-K9 with 12.3(2)JA software.Frequency Carrier Busy %2412 322417 382422 252427 802432 242437 472442 672447 222452 382457 122462 23

Hello, I'm trying to resolve a problem within very high packet latencies in a medium size wireless network using cisco 350 workgroup bridges. There are 2 root bridges (about 20m away from eachother), about 15 non-root bridges and 150 mobile clients. ...

We have two 350 Series Wireless Bridges and the extension low loss antenna cables have been run up to the antennas on the rooftops. We are unable to locate the pigtail adapter cable that goes from the 350 Series Wireless bridge to the LRM 400 antenna...

how to generate the configuration file and how to configure it using http program

how to write a config file to cisco 1200 B series Ap.how configure it.plz helpthanxmalli

We are currently using LEAP with two ACS servers (v3.0 & 3.2) in an NT Domain environment. We will soon be migrating to 2003 Active Directory. I am wishing to migrate off of LEAP but after researching I am still unsure what the pro's and con's are fo...

Hi, I am working with a 350 WGB, but when I tried to access it using a directly connected PC using a crossover cable I had intermitent responses from the WGB. Then I used a switch and a PC with the same results there are a lot of loss packets in the ...

I think there is a bug in IOS 12.3(2)JA and 12.3(2)JA2.That is with http/https authentication.This is my aaa configuration: aaa new-model ! ! aaa group server radius rad_adm server xxx.xxx.xxx.xxx auth-port 1645 acct-port 1646 ! aaa authentication lo...

Hi Folks,actually I was doing a password recovery and I deleted flash:config.txt, and then when I tried to delete /env_vars, I forgot to type the "/" character.So now the device doesn´t load the image. what can I do to recover the env_vars?? I anothe...

For rogue detection, I would like to be able to import all my switches on the network, we currently have over 400 with a mix of 3550's and 2950's. The way I see it you can only import switches on the network that have a wireless device hooked to it. ...

Hi all,I've a system, with several 1100 access points, that has two different SSID's in the same AP. One of the SSID is in "guest-mode" (broadcasting). I would like to know if it is possible to "move" a client associated with SSID "A" (guest mode) to...

In the association table for the "Entire network", I see a number of access points (AP1200s running VXWorks 12.04) with an IP address of 0.0.0.0. I am able to ping all of my access points. I know what the IP addresses for those APs SHOULD be. If I br...

I have a 1200 series Cisco AP set up do 802.1x and WPA. I can get my Cisco 350 series card to do 802.1x authentication with the Microsoft Wireless Configuration service started.However, I can't get the CB21AG-A-K9 card to do 802.1x or WPA. If I have ...

I am a little confused on what the difference is in the power settings for CCK and OFDM. The first issue is about settings for the site survey process. Being that the ACU utility is what is used during a site survey and it only supports B and not G, ...