Wireless

Reason why I am going to do this is that the pair of aironet 350 bridges have had on-off association. I moved one BR350 at a time to other site and they worked fine. There were several thunder storms two weeks ago and this happens since. I am suspect...

Our university is considering installing a wireless network to connect all its colleges together. Each college has its own traditional wired LAN. The plan is to connect all the around 20 colleges or LANs togther with a wireless solution (a sort of ba...

I am currently involved in a project linking satellite broadband & a WLAN. Both parts work independently but do not talk to each other. Do I need a switch between the satellite decoder and the access point?

I'm trying to built a Wireless LAN using Aironet AP 350 series. I'd like to use EAP-TLS with dynamic WEP key using x.509 certificates on the clients and a ACS 3.1 with RADIUS.The clients that have WIN-XP work fine. My clients with WIN2K pro SP3 and 8...

I have a customer that is using br350s to connect to 2 remote sites. We recently installed br1400s in conjunction with these. Their requirement was to pass data and management traffic across the 350 and voice and video across the 1400. I accomplished...

Hello,We have configured our AP1100 with several VLANs. VLAN1 is native and VLAN2 is our management VLAN which we use on all our Cisco devices. On our switches we assign this VLAN an IP address for management purposes. How does this work on the AP? W...

While doing some 802.1x testings. We noticed that when there is a failure in the authentication process (example server certificate expired), the AP1100 doesn't seem to provide the correct rejection information to the client supplicant, causing the s...

our university is planning to install a wireless university-wide network. the campus is spread over a large geographical area. some colleges are 5 to 8 miles apart. can someone please give me an overview of what wireless equipment i need to connect a...

i am trying to network my centrino notebook thro a smc wireless router.there are 4 pcs connected by cat5 to the 4 lan ports of the smc router.initially at the notebook i added the lan,firewire and wireless interfaces to the bridge,assigned a static i...

The configuration documentation shows how to add the native vlan. Is there a document for adding the native vlan and another vlan?bridge# configure terminalbridge(config)# interface dot11radio0.1bridge(config-subif)# encapsulation dot1q 1 nativebridg...

I currently have 3 or 4 1200 APs showing a mac address of 00:00:00:00:00:00 ...log states a possible rogue. There is no data packets transfering. The AP states it is unauthenticated. Firmware is VXWorks 12.04.I have used Airmagnet to see if I could d...

With IEEE 802.1X, does Layer 2 roaming need reauthentication ?With 6500 Wireless Solution Module, does Layer 2 roaming need reauthentication ?

We have an Aironet 1200 Access Point at our office. I have experienced a lot of problems installing adapters on laptops. After installing the software and configuring the SSID and WEP, the adapter will show that it's associated; the Access Point also...

The 802.11 standard specifies use of PS-Poll frames for use in Power Save mode. The Cisco 802.11b and 802.11a cards operate exactly according to the standard, which is good. Once they enter Power Save mode, they stay in Power Save mode, but look at t...

We are about to deploy a 'guest' ssid. The scenario we are struggling with is when a employee connectes to the LAN and the laptop automatically connects to the 'guest' WLAN (dual homed PC with default gateway on LAN). We are trying to figure out how ...