Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

We have 2 AP4800E's configured years ago. When I try to go into the configuration with the browser by typing the ip address it eventually comes up but I usually have to refresh a couple of times plus some of the options do not come up at all (page no...

dmpacheco by Community Member
  • 710 Views
  • 1 replies
  • 0 Helpful votes

Hi,I am trying to use Peap authentication with the ACS appliance. I have generated a CSR using the appliance template and submitted it on-line to Verisign. This is failing and Verisign are saying that various bits of info are missing in the CSR, such...

1) Do the 1120 by default search for the least congested channel and stick with that?2) In a large complex, wireless network are there any advantages to using least congested? ie multiple floors, lots of overlays, rogue aps, etc. By hardcoding the ...

as per my previous post, i am designing a wireless lan for a ten floor building, each floor has an area of 530 sq m, i am presuming that a 1200 access point is suffice for two floors. the total no. users for all the ten floors is 300 hence i am takin...

feline78 by Community Member
  • 837 Views
  • 3 replies
  • 0 Helpful votes

We have an Aironet 1200 with the latest Cisco IOS image on. Is there any place to set the AP to act as a DHCP server in the GUI (Browser-based Interface) or do I have to go to the command line?

Iam using EAP-TLS for client authentication. I dont want connect new user to our wired network in order to install certificate. Is possible to export certificate and install certificate from diskette or from CD?????

m.sir by Level 11
  • 587 Views
  • 2 replies
  • 0 Helpful votes

Hi,I am setting up a wireless network for a customer using ACS 3.2, MS Certificate server, and Aironet 1200 APs using EAP-TLS authentication from XP clients using the Cisco client and The Cisco® Aironet® IEEE 802.11a/b/g Wireless CardBus Adapter I ha...

Is there a utility that has the same functions as the IPSU, That can be run from command line?

universalpos by Community Member
  • 3165 Views
  • 3 replies
  • 0 Helpful votes

Is it a good idea to deploy a central Aironet 350 using a 14dBi MAST MOUNT SECTOR with all the remote sites using 13.5dBi MAST/WALL MOUNT YAGI’s? Is the mismatching of antennas considered to be good practice for wireless bridging?The reason I am aski...

whewetson by Level 1
  • 693 Views
  • 2 replies
  • 0 Helpful votes

hi folks, We are just about to deploy a new wireless LAN. Its purpose right now is for our training room for end users. Right now we have a 1100 using WPA with TKIP. I also have the AP on a seperate VLAN. I was wondering, whether this setup is secure...

oalexis by Level 2
  • 1122 Views
  • 6 replies
  • 0 Helpful votes

Hello, we are using certificate for authentication of our wireless network client(EAP-TLS auth). On Cisco ACS 3.3 is not possible Certification RevocationList (CRL) comparison for EAP-TLS. So i would like to know if is possibleto export certificate ...

m.sir by Level 11
  • 528 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card