Wireless

hallothere's any body can explain to me what the meaning of this (numbering below):Carrier Test 29%| * -94dBm| * * * * * * | * | * * * * * * | * | * * * * * * * * * | * | * * * * * * * * * | * |* * * * * * * * * * * | * |* * * * * * * * * * * | * |* ...

I would like to know, where I can find the Radio's mac address? Using the Aironet Client Utility on my laptop,I associate with the access point and its shows the radio's mac address. Can someone point me in the right direction.

Running version 4.3 of CE and trying to use a AIR-PCM352 aironet card with this device - normal installation procedure does not work. Does anykne know when the adaptor will support version 4.2? Does Cisco have a release date for this SW yet?!

Cisco is now recommending the use of local VLANs rather than end to end ones in the wired campus network. As we begin the buildout on the wireless side of our network we were wondering if this recommendation also applies to the WLAN.

Greetings,I'm having problems upgrading our WLSE to version 2.5. I'm running Windows XP on the 'repository' I was wondering if I have to install Netscape to get this to work, I have lowered the 'cookie settings'. I can see that the code is out there ...

I know how to configure the AP to enable WEP Key rotation, but do you have to enable this same setting in ACS v3.1? If so where would I have to go in the ACS to do this?Thanks

I have setup an AP1200 and client with DLink DWL-650. AP's authentication is setup as 128bit with shared key. The client is running windows 2000. The client can connect with the AP and this is verified by looking at the AP's log, I can see the IP add...

We have installed many Aironet 350 cards in W2K and NT laptops with no problem. Our CIO has a Compaq tablet running XP. I have disabled the onboard Intel card and the 350 seems to be installed OK and functioning. We use static WEP,128 bit. The tablet...

I have a number of AP1200's installed which were passing a DHCP allocated address to wireless clients using the Primary SSID (open).I now want to manage the AP's from the wired-side only. I have set up a trunk on the 3350 switch using VLAN_MAN as the...

Does anybody have information or experience integrating leaky coax with aironet 1200 aps?

Have a Cisco Wireless Access point 340 and the speed degrades as users move down the hall, away from the unit. The 340 is in the ceiling in the middle of the office. What part should I get to increase the distance for the 11 mbps range? An antenna or...

Can anyone point me to a table with the valid 802.11b channels in Brazil?Thanks!Michael Lind

Hello,I've installed an AP1100 and a Wireless client (AIR-PCI352).When I run ACU, all seems ok, I can see the AP etc..., all tests are ok too with 95%/100% signal.I can ping the AP to (10.0.0.1)Here is my problem :Under Internet Explorer, when I type...