Wireless

I know that the AP1100 can work in repeater mode, so to extend coverage where cable can't be laied. What i really think would be great is to make the AP1100 work in repeater mode trought the wired interface without wasting radio bandwith !! Any thoug...

I am a consultant in the Carolinas and deal exclusively with the Cisco wirless equipment. I do alot of site surveys and installations and I usually try to scan for existing wireless AP's prior to survey start using Netstumbler or Mini-Stumbler. This ...

I'm authenticating wireless users using MAC authentication. That works with no problem using FreeRadius. I'm trying to set the client VLAN with the Tunnel-Type, Tunnel-Medium-Type and Tunnel-Private-Group-ID attributes, but I can't get it working: th...

I have just completed a pilot for a customer, On the server I installed IAS and Cert. Services, then installed computer certificates on the server. I had to install both computer and user certificates on the clients, as well as some hot fixes and a f...

my cisco 350 workgroup bridge disconnecting from 350 BRIDGE (working in AP mode) every 5 minute +/- 0-10 sec. log history from WGB:1/20 12:06:48 I Connected to parent Cisco-3a5560 <AP-NAME>1/20 12:06:48 S Lost our association, disassociate with statu...

hello..This is my first time with cisco wlan and i need some pointers.My wlan is up and running on both the 1100+1200. and ive hide the ssid and have implemented wep .What i dont get to work is mac adr locking...i want to manuallly set in the mac adr...

Hi,we are trying to have a PEAP Wireless netwotk with WinXP and 1200 Series.I installed SP1 on WinXP professional machine about 3 months back and still don't see the PEAP option under 802.1x authentication types. The only option availabe is "Smart Ca...

I am currently designing a Wireless solution for a customer in a fairly large network. It is not reasonable to plug all access points into one physical switch in their network. Are there any guidelines for configuring switches to allow roaming for wi...

I get the following message, and all of my clients get kicked off. They then re-associate. What is this?!?!Disassociating [10.0.1.15]00072570a26e, reason "Sender is Leaving (has left) BSS"

In mapping out an 802.11a WLAN with many APs, What is the best Channel Assignment Scheme to use? What must the separation be between channels in adjacent cells? 802.11b is a 5 channel separation, What about 802.11a?thanks,Frank

My problem is that sometimes the assocation table does not fill in all information about other access points on the network. All the access points are on the same vlan. Most of the time it is the IP address of another access point that is missing. I ...

We are currently running Aironet350 LMC352 cards in our wireless workstations. and have set the Power saving settings to MAX PSP.When ping the workstations, the response time is > 100 ms (but we do not lose any packets).When we switch the Aironet car...

Repeater limit: hops or leafs?Starting with the following configuration..AP Root ---- Rpt 1 ---- Rpt 2..I know that available throughput will be divided by two if we add one more repeater to Rpt 2Question: Is the effect the same when you add several ...