Wireless

Will the "Bridge Spacing" feature of the 350 Bridge help in reducing collisions for a 2000 ft radius outdoor Access Point. Any other suggestions to help make this work? We have a central 40 ft high 8db omni antenna and each laptop is using an LMC352 ...

how can I configure certificates (PEAP) on AP350, clients? I need samples the configure

Befor about 9 months I installed 20 sites Linking to 2 Omnis in Diversity mode in a 6km radius and the network was working fine with WEP enabled using 4.25H firmware, when I added 5 more sites (using 4.25G Firmware) the Root bridge started to reboot ...

How can I find a way to use my laptop without all the wire . I want to use it anywhere at home, or on the road and be online

Hi maybe someone knows when TKIP and MIC will be supported on Linux ?all i can found states " Firmware 4.25.30 supports TKIP and MIC but the current Linux driver doesn`t !"Is there any possibility to merge the drivers from airo-linux.sourceforge.net ...

I have 3 buildings with wired LAN (Ethernet) each one.Can I connect the 3 wired LANs with a BRE500 in the main building, a AP340 in other building and a AP340 in other building?It is possible? Why?Thanks

all- when upgrading the firmware to my 350 ap, will the config remain the same or will i need to reconfigure the AP? my intent is to do this remotely via the web browser..... the current is 11.05 and my plan is to upgrade to 12.0T.thanks

I was not sure if this could be done. Is it possible to use the bridge as an AP?

we recently bought a 2 Cisco Wireless Bridge 350. In order to activate the WEP Key does I need to install software inside my wired client PC.

I´ve a Ap340 and two days ago i notice a problem only one client at a time can be online. In the AP logs it appears the following message: <mac address> Too many stations in BSS.Any one knows how can i handle/resolve this?Thanks in advanceSergio Mere...

We are deploying Wireless carts with Cisco Aironet LMC-352 PCMCIA cards with a single (MMCX) pigtail connector running up to a "rubber duck" antenna mounted to the cart.My question relates whether I should keep the default setting of diversity or whe...

How many users can be working at the same time on one AP350 Series?I suppose that there is a limit number of simultaneous users associated on a AP350, but how many of them work fine at the same time? What is the same: what is the maximum number of us...

I have create a Configuration Backup of a WGB 350 with "Backing Up Your Configuration (Dump) "now I have a new WGB350 where I must restoring a copy of Configuration; I have tried with FTP, the transfer is completed but the WGB configuration that I fo...

I only want to know that under the frag threshold option the number refers the ip packet size or the MAC frame or this number contains everything also PHY overhead?

I currently have a Cisco wireless LAN solution engine that is reporting several "FCS Error is in Overloaded state" messages on several access points. and also"Packet Error is in Overloaded state" These error messages will be followed by another messa...