Wireless

I would like to have some information about the radiation pattern of the Cisco AIR-ANT4941 (is this more or less a standard (folded) lambda/2 dipole) and of the antennas in the Cisco AIR-PCM350.Also, could anybody tell me how much the Cisco AIR-PCM35...

I have Cisco 350 Bridge in AP mode, and i have a couple D-link , Linksys etc bridges linked as AP clients. The problem is that computers behind the bridges are not abble to communicate through Cisco 350. When client frames are sent , the bridge is di...

I have PC with Win 2000 Adv Ser and 350 Client Adapter with firmware 4.25.30 and NDIS 8.2.30. I have AP 342 with no encription, open authentication and default SSID (tsunami). The problem is: 350 Client Adapter is authenticated with AP but not associ...

I want to know the structure of 802.11b frame. where can i find the relevant document?

Which is the best option to use?????Aeronet 350 Series or We can use anything else???

I'm using two bridge wireless to send files from a pc to another 100 meter far.we can call one pc A and pc B.Supposing that the direction of transfering is from A to B the data rate change : 5 Mbs if the command to start copy is given from B 2.5Mbs i...

Hello,Up to 3 SSIDs can be configured for a single profile in ACU. Supposingthat 2 SSIDs are configured, and these 2 SSID are existing on theAccess Point, what is the selection process between the 2 SSIDs.I thought that SSID1 was preferred, but durin...

Hi everybodyDoes anyone knows how to create a Certificate Signing Request from a PIX 515. I want to make a VPN tunnel between 2 PIX with certificates and the Onsite Verisign ask me for a CSR file witch must contain the public key and the name in an e...

I'm looking for some feedback on the following percieved issue. Assumptions:1) A PEAP implementation where PEAP authentication is configured to use a static NT user/pass combination as credentials. 2) The ACS has an unknown user policy to check the N...

I am seeing the data rates cycle from 11 mbps to 2mbps and then sometimes a very short spurt on 1mbps. I set the 350 AP custom data rates to 1 basic, 2 basic, 5.5 no and 11 no.I have a client on win 2k with a 350 pci card installed but I see the same...

I have 2 ACS server running as primary and secondary.I have a wireless client conected to the AP and using LEAP autn. with the ACS.From the ACS log, I found that, the authentication is done by the ACS2 ( passed authentication page ) but the acct. inf...

We just installed two AP1200 with ANT 5959 in biology and chem labs at a college. The system works fine. The ANT5959 is designed to clip onto the ceiling tile t-bar of a drop ceiling. The problem we have is that they sag slightly (about quarter inch)...

I am using MAC address and LEAP authehtication via ACS, MAC address is configured as user in ACS database and LEAP using external windows user database.If this is a case, can someone use the MAC address as username and p/w to login to the network ?If...

Hi all, I just installed this new AP 350 and finished configuring it. About every 15mins, a warning appears in the event log:Ethernet Link Lost. Attempting to re-establish link to primary network.Everything appears to be normal however, I can connect...

I have a WLAN. It has all the latest and greatest security features available from Cisco. I have now been asked the following:a) a user that connects should be limited to a preset list of ports (i.e. 80 and 53). How do I go about doing this?b) a user...