Wireless

what is the use of a separate strong CHAP/MS-CHAP password in the ACS user setup ? Document said it need to be supported by the AAA client. Do I need to configure anything in the AP ( AAA client ) to match this password?

I have configured LEAP+MAC authentication through an ACS. The first time a user tries to connect there is a MAC authentication and a LEAP authentication. But every 10 minutes there is a LEAP re-authentication of the user.Is that normal? are these 10 ...

Please any one can advise me why the bridge said that it works at 11Mbps but when we do a testing with 2 Aironet bridge AIR-BR350-E-K9 the maximum throughput I can get in the idea situation is 6.6 Mbps only. So what is the real throughput of Aironet ...

Ok, I'll be the first to confess I'm an idiot......I have to install a shot tomorrow, and left all the hardware at work. Today, I'm supposed to be going out and getting the masts. Without the "U" bolts on hand, what diameter mast should I be buying. ...

Whenever I removed an allowed MAC address from the filter when the MAC address is still associating to the AP, I have an intermitently timeout access to the AP from wired LAN. If the MAC address is not being used at that time and I remove it from the...

In passing this Access Point from One Engineer to another someone has misplaced the power supply for this access point. Can anyone tell me what pin-out and mW is for this 5VDC input is? Looking into the connection, which is arch shaped, there are thr...

I am using MAC and Leap authentication thru ACS. The default unicast filter is disallowed. However, when I tested the MAC auth out, some MAC address in the allowed list can pass but some are failed. even the MAC is allowed. Any idea where I have miss...

I got a CISCO AP Aironet 350 setup in a lab with a RADIATOR (RADIUS) Server.I want just MAC authentication with RADIUS, no WEP, no anything else, so I setup my AP following the guide on the CCO.The first time a associate with my Laptop+Linksys WiFi P...

hi,Does anyone know an overviw document about personal comm. service (Cell phones) that I can get from the net? Many thanks. Dr. Abdullah

I would like to have some information about the radiation pattern of the Cisco AIR-ANT4941 (is this more or less a standard (folded) lambda/2 dipole) and of the antennas in the Cisco AIR-PCM350.Also, could anybody tell me how much the Cisco AIR-PCM35...

I have Cisco 350 Bridge in AP mode, and i have a couple D-link , Linksys etc bridges linked as AP clients. The problem is that computers behind the bridges are not abble to communicate through Cisco 350. When client frames are sent , the bridge is di...

I have PC with Win 2000 Adv Ser and 350 Client Adapter with firmware 4.25.30 and NDIS 8.2.30. I have AP 342 with no encription, open authentication and default SSID (tsunami). The problem is: 350 Client Adapter is authenticated with AP but not associ...

I want to know the structure of 802.11b frame. where can i find the relevant document?

Which is the best option to use?????Aeronet 350 Series or We can use anything else???

I'm using two bridge wireless to send files from a pc to another 100 meter far.we can call one pc A and pc B.Supposing that the direction of transfering is from A to B the data rate change : 5 Mbs if the command to start copy is given from B 2.5Mbs i...