Wireless

Is it posible to Downgrade the Firmware on a 350 Series PCI Wireless Adaptor Card

I tried to implement a solution to authenticate both MAC address and LEAP for wireless client using Cisco ACS. However, it seems that as long as LEAP authentication passed, no matter the MAC authentication was configured properly or not, the user cou...

We are going to deploy Wireless on our network. Beside the suggested Cisco policy for securing wireless we also want to to secure it with VPN. Has anybody done this that can point me where to start. We have a 3000 concentrator, can I user the externa...

When using Aironet 350 PCMCIA card as my network device for Enternet PPPoE client, my PC gets very slow each time traffic is transmitted. I do NOT have this problem when using the wireless card without the PPPoE client (ie within a LAN). Is it a know...

Hello, I have not devices to test and i have a question: Can I use two devices configured as repeaters in a hot-standby redundant configuration. I think that's only possible if the standby one monitors the main device via Air-interface (i think that'...

What does it mean "Wireless Bridge in AP mode"? Is it same with "Wireless Bridge in Repeater mode" or not? What is the different? (In point-to-multipoint environment)Which devices can associate with Wireless Bridge in Root mode and which with Wireles...

Hi, with the above WLAN Equipment installed, there are approx. twice a minute a link loss. But not with Labtops with the same PCM352 and WIN 2000 is installed. Has anybody a clue abaout this issue. Regards Richard

What is the OID for the ethernet port/radio port on the Ap 350/1200 or 340.How can i find it using snmpwalk or snmpget ?

I recently depolyed two labs each lab has 2 1200 access points set up as roots and 30 pcs. I have the power set to 30mw on each access point. The problem I am having is when students log in in these classrooms at the same time it takes about 6-8 minu...

I have two Aironet 340 Point Access and I want connect two wired LAN that are in different buildings.I have configurated: -> 1 acces point / root -> 1 client / non-rootThe "association menu" say: The client is associated with the access point, but th...

Just wondering if you can distribute WEP keys to AP's without going to each AP.

I am configuring a number of Cisco AP 350s for Cisco LEAP. If "Rotate Broadcast Key" is enabled, is it necessary to enter a static WEP key to be used to encrypt broadcast/multicast packets? If Cisco LEAP only is required (Network EAP is enabled as an...

Hi. Can anyone tell me if a Cisco Aironet 340 Bridge (BR342) acting as an access point will support LEAP. Does the client have to support it? Or does the access point have to support it? Or both? If Windows XP supports it, does a 340 client adapter h...

Does anyone know if the 350 Work Group Bridge has any limitation on protocols it supports and can pass. Trying to get Novell clients to pass through a WGB to an access point that sites on the Network whrere ther servers reside.-pat

I was curious to see if anyone has ever heard of this error message, TAP Terminate. It is an ASCII text message that is being generated on several of our RF Scanning Guns. The guns are connected to the network via RF AP using IEEE802.11 technology. S...