Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi all,I would like to have an aproximation to the "most sold" wireless outdoorproducts. I mean, the ones who allow you to connect two or more buildingsand in the same time have can act as Access Point.Thanks
i need to suggest to a customer a voice solution over wireless links. The network configuration is as below:one central site with 3662 router & 9 remote sites with 1750. all the routers are equipped with voice ports. The central site is connected to ...
PROBLEM/QUESTION Users are currently authenticated by an ACS server when remotely accessing the network through a VPN. So their user accounts have been created and there is currently no value for [027]Session-Timeout RADIUS attribute. What will happe...
I have to install Aironet 350 wireless bridge, but the distance between anteena and bridge will be more then 75metre (due to some LOS issues at site) so how can I have low loss cable of 75m when from Cisco, maximum 150ft cable is available??
When inserted Intel wireless 5000 cardbus into Cisco 1200 access point emty slot, 1200AP has reloaded, but not find new hardware. Perhaps, third vendors 802.11a cards can not use in Cisco Ap's? And we must wait Cisco hardware releases?
I have been tasked to install some Cisco Aironet 350 Access Points. We are utilizing our Raduis server for authentication at a site connected via 3MB WAN.I've been told that I can only have 3 access points at our site because of site survey that was ...
How many antennas needed for the 350 series access pioint ( AIR-AP352E2R-A-K9 ) ?Can we connect the antenna AIR-ANT4941 directly to the aboce access point ?
what's the relation between Gain and transmitted power with coverage area?if we want add coverage area, could we just add antenna's gain only or add transmitted power only?
I would like to know if you have any issues of signal problems of the Aironet Solution with any wireless telephone system usig the 2.4 GHz bandwith.And if you have seen any problems can we use the 5GHz equipment in Mexico
Has anyone found problems (dropped packets, etc) with clients running terminal emulators over a 350 Bridge-to-Bridge connection?I'm getting people 'kicked' from their terminal sessions, yet the network is running perfectly. I have adjusted the Frag T...
