Wireless

I am looking for any info on available or coming products that offer wireless phone/radio voice capability over 802.11b or other wireless networks. Basically a modern and cost effective alternative for an in-house radio network based on the LAN infra...

I have two 350 Bridges - one root, one non-root w/o clients. We're using Air-Ant-1729 antennas. The bridges are in opposite buildings that are directly across the street from each other. Our signal strength doesn't go higher than 62%. What factors mi...

How can i connect directly the Aironet 350 to an ADSL Router 827.Do someone know the Cable pin's for Aironet ----- SOHO 827ThanksErol

Has anyone ever tested Compaq Evo N800c internal wireless LAN card (Intel) working with Cisco Aironet 340 or 350 access point before ? How to make it work ? Any useful relevant information on this ? What are the usual reasons why one particular LAN c...

We have an application on PPC 2002 in a Hospital, and we want to use LEAP on the AP350 card. Now this works fine, but every time you power cycle the iPAQ you have to enter your logon credentials again, and as the Doctor walks around the ward doing th...

1) To conform to the standard, the total output from the AP cannot exceed 36dbm, it depends on the countries. The maximum power in an AP is 100mw, is about 20dbm, please correct me if I am wrong, does it independent of the antenna gain which I use? D...

Hello, I''d like to use a Radius to dynamically authenticate wireless users, but I'd know if it's possible to assign dinamically address to the wireless port, when accesing to the RADIUS, or validaing it to avoid wireless clients of changing their IP...

I would like to extent the range of a radio network by connecting two Bridges back to back via an Ethernet crossover cable. Presently the one bridge is a non-root, which associate with the main root bridge at the core of this network. The second brid...

Anyone using Cisco 350 APs with Telxon/Symbol 960sl handhelds and Powernet Twinclient manager? We interface with an AS400 and are having response time issues, high CRC errors along with host disconnections. Does anyone have any suggestions?

Currently I am doing MAC auth in the AP but since the number of clients are increasing I would like to install a central MAC auth server. What choices I have OR is Cisco ACS the only option?

I am looking for information as to what will be required to build a multi-home WIFI network. Initially only 2 homes but I would like the option to expand to additional sites in the future. I need suggestions for equipment and general architecture.Pau...

Currently I have a project to monitor and control 3 lifts. In normal situation, we will lay a cable from the PLC controller located at the motor room (normally at the top floor of a building) to the control room (normally at the 1st floor or basement...

I'm working on an SCADA / MES software solution in a meat processing production area. I want to have an ethernet connection to all PLC controled machines. Some of these machines can be positioned anywhere on this production floor, so I'm considering ...

I know that there are endless ways to skin this cat, but am wondering what methods anyone is using to to document wireless cells and coverage areas. I'm looking for a better way. email me directly at lhbadman@syr.edu with input...Lee

Hi,I under from the Aironet 1200 specs that the range (indoor) is 40m @ 11Mbps. I have an auditorium which seats around 350 users. I was thinking if it is possible to lower the transmit power to a range of only 5-7m so as to allocate more APs without...