Wireless

I am looking for a product that i heard that cisco offers. The product that is in question is a wireless non-line of site acces point that will cover a 30 mile raduis. If anyone has any detail or that can point me in the direction of what i am lookin...

I have a routing problem but I just can't figure out where.I have 2 nics that are associated to AP #1 which is setup as a repeater. AP #1 talks to AP #2 which acts as the Access Point to my wired LAN. I can ping the IP address of my server from both ...

Will the Aironet 1200 support any type of IP Multicast.If so which type?

Which is the better solution for individual telecommuters; Connecting to Wired LAN through point to point wireless bridges and access points or VPN-broadband connectivity, using VPN concentrator at the central site and VPN S/w or H/w client at the us...

Can anybody please explain:The LEAP authentication process when authenticating against an NT SAM - Does the password entered at PC boot up also go to the RADIUS server at the same time? How roaming work with per session based WEP keys? - Are the keys...

At this moment, I will like to know if Cisco Mobile IP solution has the security feature that provides end-2-end VPN IPSec tunnel for Mobile Node -> Mobile Router -> Foreign Agent -> Home Agent ? Now, I know that FA-HA will either have IP- or GRE- tu...

Is this possible within the AP itself.I would like to be able to secure access between clients on the same access point. Is this possible.? I don't want to have to do any type of VPN.There will about 10 users per access point and there is a need to s...

Hello, i am very confused, its possible to setup the AP350 (11.21) to only associate with specified MAC addresses and block all others ??When i set up a Mac filter only the dissallowed rules work - why ? what i doing wrong, any help would be apprecia...

Hello Eric,I currently have an Cisco Aironet Wireless AP, which was disconnected from a network that no longer exists. When this AP was connected to the network, it was configured with two addresses for ACS Authentication servers. Unfortunately, thes...

If I am using 128bit WEP and enable the TKIP and MIC features on the AP and clients -- what sorts of attacks am I still suscpetible to? Take for granted that the people using the gear are who they are supposed to be, etc -- I am most interested in wh...

Hello, i am a bit confused, how i can upgrade the Radiofirmware of an AP350 ? the installed version is 4.25a, I use System Firmware: 11.21. Where to get the file for the RadioFirmware ?Why my AP350 shows the following @boottime : h) FLASH :340 Series...

Can a Aironet 340 Bridge be turned into/used as a 340 Access Point?Can I just change a setting and switch into AP mode vs. Bridging mode? Or can I load up the AP firmware on the 340 bridge?Thanks,

In my world the Cisco Aironet 350 things are being used as bridges - simply replacing slow APL-lines. As so, I realy hate the menu-based setup on these boxes. An IOS-like command line is far preferable as I'm able to generate a configuration and now ...

Hi We currently have a campus wide switched network consisting of Cisco 6500 and 5000 series catalyst switches in the core feeding 1900 series catalyst switches at the edge.We use DHCP and VMPS to determine IP address and VLAN information for each ho...

I'm using an Aironet 350 AP with 11.21 firmware and tring to apply an IPX filter on the radio side of the AP. I created the IPX filter using 0x8137 and 0x8138 ipx protocol and set the disposition to block, but when I apply the filter to TX and RX on ...