Wireless

We have a wireless lab in a large high school and we can only get 4 laptops to connect a time. Is there come configuration problem that we can't find? Also, how do you connect locally to the Aironet 350 to administer it?

It seems there is no point to use diversity with two omnidirectional antenna's on an access point since the AP will only use the antenna with the best reception, is that a safe bet? Will the 350AP work fine if I configure it to use only one antenna f...

eg I have 2 APs on channel 6 with SSID = ciscowhat will happen when 2 APs CROSS each other?what happen to client in CROSS region?what happen when client roam across?

Hi I'm a student who is trying figure out how to configure Woreless Network to an internetwork. What would be the proper steps to implement such a network in a two floor facility that is 344sq.ft? We have downloaded the ACS from the web and we are us...

hi groupthis is my first post here.i have a small office less than 20Metters with 10 laptop computers, i would like to share the internet with the laptops and to setup wireless LAN, there are too much choices from Cisco i do not which one will woke t...

I am tring to get my 340 card to talk to my Linksys WAP11 at home. It works fine with WEP turned off, but when I configure 40 or 128 bit WEP the system fails to pull a IP address. Has anybody configured this card to work with the WAP11 using WEP? If ...

Hello,Can anyone give me information regarding data transfer using mobile phone.TksKallol

Hi, I would like to load balance a group of 50 wireless users with two AP in an office area. What are the conventional and effective ways that I can do to achieve that? Tks.

I have two 340 Series Cisco/Aironet PC cards. When I run the Client Encryption Module on one of the cards it states that "WEP support has not been purchased". I didn't know you could get it without that option. I have upgraded both cards to Firmware ...

I am sorry if this has been asked before or it is the wrong place to ask this.I just want to know how secure is MAC-Based Authentication on an AP340 access-point (not bridge) with version 11.07.I've done this by adding 'Dest MAC Address' in 'Address ...

Hi all,In warehouse or manufacturing environments where there are a loarge number of clients and a large number of APs (350s in our case), the 350 seems to wait until the quality of its association is really lousy before it tries to roam to another A...

I have a AP350 in my home connect to a switch that is connected to a cable modem. All PC's that I connect to the switch get a different IP address thru DHCP. My problem is that I can not get more than one device to Associate with the AP. I have two 3...

RF scanner i use is comply to ieee 802.11b. It has been working fine with AP4800 and 340 Series. BUt when i tried with 350 series, it just didn't work out.I understand that i just need to put in the SSID and no other configuration requires.But it sti...

I have just set up 3 Aironet 350 APs, all signals overlap and all APs have the same SSID.All APs are also set up on differant channels (1,6,and 11). I'm also using LEAP. I'm using Compaq iPAQs with the Cisco Aironet 350 PCMCIA cards as the clients. E...

Anybody know what chipset the Cisco card uses? Can't find it in the specs.