Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Welcome to the Cisco Community Ask Me Anything Event   Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...

Shree Hari AB.jpeg Screenshot 2026-09-11 at 3.12.04 PM.png

I've got Aironet 340 with the Cisco wireless LAN Adapter card. this works fine when they are both used. I've also got Toshiba Tecra 9000 laptop with built in wireless LAN adapter.The Toshiba doesn't seems to see the Access Point with its built in ada...

sakinnusi by Community Member
  • 1727 Views
  • 5 replies
  • 0 Helpful votes

I am trying to put a plan in place for our sales staff (who are on the road alot), I would like to get in with a large wireless provider to help in this endeavor. I cannot find a good single source provider. Does anyone know of one.

We have buyed 2 wireless bridge AIR-BR350-E-K9 but in configuration is impossible to set this 2 units as bridge, there are only 3 field: As AP, as repeater and the last as client.Someone have had this kind of problem?

lbacchi by Frequent Visitor
  • 1372 Views
  • 2 replies
  • 0 Helpful votes

I have a couple of AP340's set up to do LEAP authentication via RADIUS on ACS. All of my clients, until today, were Cisco NICs. I have a need to enable and configure MAC authentication for a Lucent NIC. Has anyone had any success enabling both LEAP a...

r.crist by Level 4
  • 1106 Views
  • 2 replies
  • 0 Helpful votes

The following question/answer was taken from a past Wireless Tech Talk. Does anyone know if this includes the 4800 AP when upgrading from 11b to 11g? Or is this for 340's/350's only!What is required to upgrade AP's from .11b to 11g., then from .11g t...

rx33328 by Community Member
  • 846 Views
  • 1 replies
  • 0 Helpful votes

I have two Lucent (Orinoco) access points, the AP-500 and the AP-1000. I have the 128-bit WEP encryption enabled and currently the use the Orinoco Gold cards to access the network. Everything works fine. Now I have a need to use a wireless Cisco card...

edski by Community Member
  • 1036 Views
  • 3 replies
  • 0 Helpful votes

In Windows 2000, my Cisco Aironet 350 series cards ACU window had a checkbox in the "System Parameters" tab of the "350 Series Properties" window. The checkbox appeared under the "Default Profile" section. It said "Enable Auto Configuration Switching...

n_okla by Community Member
  • 1180 Views
  • 2 replies
  • 0 Helpful votes

I have two routers and between a PIX. Fact is that multicast traffic on a PIX isn'tallowed and I will not create a GRE tunnel.I configured on the two routers OSPF with theneighbor commands and permit OSPF on the PIX,but it doesn't work, so has anybod...

saner by Community Member
  • 767 Views
  • 1 replies
  • 0 Helpful votes

I'm looking to get into wireless networking. Starting next semster I will pick up some general books about wireless but I wanted to read up on some Cisco too. I've been searching all over for a Cisco Wireless Certification and Cisco books on wireless...

bmckean by Level 2
  • 989 Views
  • 3 replies
  • 0 Helpful votes

Hi,I have two ISA based 340 series aironet cards. Recently, I have started to upgrade to more modern systems, but I cannot use the aironet cards because all of my new motherboards require PCI cards. Is it possible to purchase new PCI carriers? I woul...

b.byler by Community Member
  • 785 Views
  • 1 replies
  • 0 Helpful votes

I currently use a Cisco AIR-LMC342 PCMCIA and the Cisco "Rabbit ears" antenna to connect to the 802.11b Internet provider in my area. I want to up grade to a better antenna mounted outside the passenger compartment.Questions:1. What mobile antenna pr...

thetaxi by Community Member
  • 991 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card