Wireless

Hi, I am not sure how many of you are seeing problem like me, In my 9800-CL HA SSO deployments active role switchover occurs from chassis 1 to chassis 2, show chassis says chassis 1 is removed, active chassis logs ha_port tx hang message, by looking ...

There is no ssid signal after AP left the first WLC and join to the second WLS. The two vwlc are same model and should have the same configuration. and have the same ap group. Any suggestions? Thank you

I just set up a Cisco 5508 WLC and a 3702 AP. The AP is in flexconnect mode. Both the link to the WLC and AP are trunks. Both are using VLAN 255 as their managment ip. Facing the AP I used "switchport trunk native vlan 255", and am able to reach it o...

I'm installing a few WAPs in very difficult to reach locations. Does anyone have any recommendations on a remote serial console device I can connect to the serial port on the WAP that I can run an extra cat6 cable to at the time of install? I'd rathe...

Dears,I have problem with AIR-AP1852I-I-K9 it was working from 2 days, today i have if flush (RED), i have connected form console i have found the below and no user name or password appear  r no heartbeat fo r 180s[*01/31/2021 07:58:38.6089] watchdog...

is there a way to add dynamic timestamp to the file name in the "transfer upload filename" command?

I have a Cisco AIR-A1832i-B-K9.I was intended to reset the AP to factory default, however accidently it resulted in  clearing the AP’s internal storage, including all configuration file. I think it also removed any regulatory domain provisioning made...