Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
I am trying to find the OID for the wlc temperature for the following model wlc: 3504550855205810I am trying to create alerts in SolarWinds for high temperature, but having a hard time finding the OID.
I am looking to know all the functionality of the splash page config for cisco. Meraki has a page like https://documenter.getpostman.com/view/897512/meraki-dashboard-api/2To9xm?version=latest#79612cda-002c-45fb-9f88-6e3651b780ab Does cisco have some...
Hi AllI have set up my foreign and anchor WLC, however for some reason im not getting any DHCP addresses from my anchor controller even though the scope is setup etc.any ideas why not ?cheersCarl
Maybe these days somebody struggles the same way like I did last week. So if you want to use the embedded 9800 WLC (often called eWLC) on a catalyst 9300 switch. You have to download the special releases from this site: https://www.cisco.com/c/en/us/...
We are replacing this appliance and I want to clean all our specific information off of the appliance. Restore it back to factory defaults.I tried the "application reset-config" command, but that tell my it's not valid in this version NCS?How can I ...
Good day. After raising the vWLC firmware version from 8.1.120 to 8.5.131, some points stopped connecting to the controller, the log shows (AIR-LAP1141N-E-K9) is unsupported, tell me what to do?
Two AP that act as a controller have the same configuration? -system name IP management:- IP/mask/default gateway-SSID thnks
Is this because the difference about WPA2-PSK Security and Mac Filtering Security ? it can say that its the weakness of Mac Filtering Security, this is below the scenario test I have tested that with this scenario my mobile phone connect to SSID A i...
Hello All I just replaced one of my old Server 2008R2 NPS servers with a freshly installed Server 2016 installation. I exported the NPS configuration on the old and imported it on the new one and also registered the new one correctly in AD. Did some ...
Hello!What refresh position rate if client connected and send data?I need about 1s refresh.
We’re looking for network operators and engineers to complete a 2-minute icon preference study. The icon choice will help us better represent information on a Cisco software product. Click here: https://ciscoux.az1.qualtrics.com/jfe/form/SV_6saOh5s...
Resolved! MESH works, but no ping to APs
Hello, I have a 2504 WLC controller. I have tested all the stable and intermediate versions of the controller software like (AIR-CT2500-K9-8-3-150-0.aes; AIR-CT2500-K9-8-5-140-0.aes ; AIR-CT2500-K9-8-5-151-0.aes, as well as their bundles). I have 7 ...
Kindly confirm whether the AP 2600 series supports the IEEE’s new 802.11ac specification or not.
Resolved! Moving configuration to a new N+1
I have a pair of WLC on HA, and I'm adding a new on as N+1, is there a easy way to migrate most of the configuration without having to setup the entire box again?Thanks, -Dave
