Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
Hi Experts,going throught the Cisco docs, it is not clear as to what is the recommended height for Outdoor APs:Wireless Mesh Access Points, Design and Deployment Guide says: "MAP deployment cannot exceed 35 feet in height above the street."Aironet 15...
We currently have a Cisco 4400 series wireless controller with a mixture of AIR-LAP1242AG-E-K9, 1142N-E-K9, 1131AG-E-K9 access points connected to it. We are looking at migrating over to a new wireless controller (Cisco CT5508) and initially replacin...
Hello, I have a single WLC with a single interface that is trunked to the network switch.I have 2 SSIDs one for Guest and one for the company users. both the networks are setup and ISE is authenticating the users SSID/wireless LAN. The Guest is open ...
Hi Guys, Our customer would like to accomplish this:- Only specified domain users can connect to corporate SSID from domain PCs. So:- Non-domain clients (PCs) not allowed to connect to the corporate SSID at all. (regardless of the user)- Users who ar...
We have an HA pair of 5508 controllers & 3702i APs & are considering adding 9130 APs. Will the 5508 support the 9130 model AP? Are there any issues with a mixed 3702 & 9130 environment? Does the 9130 ship with its own mounting bracket?
Dear Buddy,I have 2 WLC 3504 with HA configuration, when I power off Active unit, it works normally. The issue occour when I power on Active unit and it comes up, the Standby unit will reboot. And when Stanby unit comes up again, Actice unit will reb...
Error message: NVRAM verification Failed.I assign a static IP address on the interface BVI1 of WAP 3602i from console connection.
I am looking for some clarification before I go ahead and install/reboot my 5508 WLC pair.The webauth certificate is about to expire so I have chained a new cert together. I have dual 5508s in HA mode and have uploaded the cert. I am now faced with a...
Note the allowed frequencies.. On 3 other AP's this has values.. Same with allowed power levels.interface Dot11Radio1 Radio Antigua 5, Base Address 00a6.ca6f.96c0, BBlock version 0.00, Software version 4.18.1 Serial number: FOC20304KTF Unused dynamic...
Hello everyone.I hope you and your families are very well, this post is only about your experience and your knowledge about the integration in CMX Detect and locate module with the airistaflow products. This is because I currently perform location ba...
Hi guys,Anyone have info on what is the max height an AP can be mounted?Could not find this info on any doc.I am using 3802i (internal antenna) type APs and will be installing in a high ceiling environment.Thanks.
I have encounter issues with prime and is slow and will logout. Sometimes it took 30 minute to login to the prime GUI. When I check the ade# on cisco prime there are still leave 77GB of space for a total of 117GB which is understandable still have re...
Dear allWLC Cisco mobility management can join with same mobility but version different version WLC ?i don't see in document.
Cisco 3504 Wireless ControllerMac address under SSID disappear, after power outage. how to verify this issue? Thank you.
Hi,Maybe someone already have the same kind of problems. We have a wireless infratstructure where all devices works fine, except our Teklogix scanner for the warehouse. They never seems to have a good quality signal. The singal quality always move fr...
