The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
This is very high level, wanting to know if this is possible. We're the middle man. I don't have access to or knowledge of equipment or configs on the other providers. Currently we are handed off a GRE tunnel to a router. We have an ipsec tunnel ...
Hi,I have four SPA303 IP phones which I’ve wiped and reset, and can access from the browser using the IP gateway. I’m looking to use these phones for internal calls only. Can this be done without any hosting service, and is anyone able to give me som...
So I've always just had unmanaged switched.... 4 port TPlink POE stuff but I was gifted one of the 3650 switches.I'm thinking it might not be plug and play as I know it acts as its own DCHP server / vLAN management etc which I don't need since the ro...
Hello Team,I tried using the attached method to physically reset the access point in order to forget the known WLC IP list, but it didn’t work. The AP is still attempting to join the WLC that I don't want it to join via the known list.Could you pleas...
Attached are the settings we have for Web Auth and the signed certificate attached to the web auth. Before we attached the signed certificate and attached a hostname, users connecting to it would get redirected to 192.0.2.1.Since there was no certifi...
Hello everyone We have a Cisco Wireless Controller 2504, and we are having issues when trying to connect to a SSID with Web Authentication (or Web-Passthrough) configuration on Windows 11 computers. On Windows 10, iOS and Android works fine with no i...
I have few webex channels with unsend message indication icon. This is the icon And info above it: Which means: Message was not send. How to clear this icon?
Greetings, I'm creating a system that requires a TAA(Trade Agreement Act)-compliant switch be used. I have a SG500X-48p, SN: DNI181602C0. How can I verify whether the device is TAA compliant? Thanks in advance for any responses.
Hi,Could you please anyone answer following question:any differences between Cisco IOS software in the USA vs Overseas?any differences between deploying wireless in the USA vs. Overseas?Thank you
Quinta-feira, 17 de Fevereiro de 2022 às 15h Brasília BRT* Evento Quintas Quinze MITRE ATT&CK e a Arquitetura Cisco Secure Uma vez que uma organização é violada, os adversários normalmente ficam à espreita nas redes por meses antes de serem detec...
Hi guys!I'm pretty new to Cisco routers and learning alot from configuring a Firepower 1010. At the moment I can't use CLI as the router is in another place. I would benefit from doing this through ASDM since I'm using VPN to get to the server which ...
It's my first time configuring multicast on a switch. Do I need to configure both Layer 3 and Layer 2 for multicast on a single VLAN that is in DHCP? Should I enable IP multicast routing on Layer 3 and PIM sparse-mode on that VLAN? Also, do I need to...
Hi how are things. I need to enable the condition in Cisco Ise 3.2 so that one of the conditions is to validate that it is Windows 11. How can I make that condition be met in posture? could you help me