The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Does anyone know how to factory reset the C9800-40-K9 WLC? My local password is not working after reboot, and I am having a hard time finding factory reset or password recovery instructions.
When I try to log into the SNTC portal, I get auto forwarded to promo page. It says I don't have access when I am able to see my account on the Access manager page
Hi Team,We are going to replace a new hardware cisco ISE appliance. I want to understand few qureies regarding this.1.While powering on what are the necessary steps we need to perform to confirm the health of the hardware like POST?2.If i connect to ...
We have currently started implementation of the critical VLAN and have created the VN on DNA and have the SGT created on ISE but a scenario came up when we started testing and that is how the critical VLAN is going to work in an extreme situation whe...
Hi folks,Running a Catalyst 9800-40 WLC. 1463 WAP's connected, predominantly C9136I WAP's. 8,817 active clients with 4,796 clients on our SSID using PEAP authentication via ISE on the back end. We are observing clients will frequently disconnect fro...
If you don't see counters on the Cisco ISE dashboard and receive the message "Unable to load Context Visibility page. Exception: Elasticsearch exception [type=search_phase_execution_exception, reason=all shards failed]," you can follow the procedure ...
We have seen issues with a Cisco 5500 and 2405 WLAN controller with older and the latest controller firmware(8.x) of not forwarding the first EAP Response frame to the radius server on 802.1x WLAN devices doing full authentications. The first EAP Res...
Introduction Critical VLAN was introduced to address the situation when the fabric edges are unable to reach the configured RADIUS servers due to some outage such as a WAN outage. During this outage, authentications are not possible for newly conn...
Tengo actualmente 3 Switches Cisco Nexus 3048 y he buscado información de como habilitar la administración web, sin embargo hasta ahora no ha sido posible. Por referencias de algunos sitios en internet detallan que son administrables por Web, alguien...
Is it possible to specify the OS file located in usb0: for the OS installation when executing the request platform software sdwan software install command, instead of using the OS file in bootflash? If there are any precautions or points to note, ple...
As we've started to roll out ISE to more and more endpoints, we have started to see some odd behavior in context visibility. The oddness seems to be related to docking stations where various endpoints throughout the day are using the same docking st...
I started to work in a company where the position of network administrator was opened, the company is already quite large in terms of amount of equipment, everything is already interconnected correctly, I would like to know what would be the next ste...
In our office in Zurich we like to block an specific outgoing number.We have created several route paterns what will block/reject this specific number.But we like to do this on the router instead of the CUCM.Has someone a suggestion?Thanks in advance
Is it possible to do NAC for HP Color Laser printers. Printers are connected to Cisco switches.Requirement is only these printers should be permitted to connect to the switch. Any other switch connecting, should not be permitted in the network.
We are currently developing a web application and are looking to integrate it with Cisco Jabber’s telephony services. Our key requirement is to trigger voice calls from our web application and retrieve the associated call session ID for call manageme...