The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hello, I have a Nexus 9000 and unfortunately can't use Prime for management. I want to copy the current configuration to a sftp server using passwordless public key authentication. I have configured a local user without a password and generated a pub...
Hello Fellas,I'm new to this community. We deployed an SDWAN in our organization. Our set up was 2 Internet ,1 router edge. We configured NAT(1st Internet) but every time of failover (2nd internet take over) our NAT was working. We want that every t...
Hi, one of our clients runs a 2 Node ISE Deployment in a lets call it "very specific" environment.New reqirements should be be fulfilled by keeping the IP Address on one of the nodes but move from /27 to a /31 subnet mask on the ISE Eth0 interfaces. ...
Hello everyone.I am currently using WLC5520-8.10.196 and AP9115AXI in the office. I have noticed that some clients occasionally roam to farther APs. These clients are all Intel's WIFI6 network cards. The frequency band of AP is 80MHz.The AP3800 serie...
Hi Expert,Recently, one port on our 9200 switch went to err-disable state and the status LEDs are all off. The port configuration is as below: it is connected to a desktop PCThe logs is as below, it looks before it goes to err-disable state, the port...
I have a Prime Infrastructure installation that was set up over ten years ago, with C4900M and C3750X switches, 5508 WLCs and 3700 series APs.Authorization was set up against an ACS applianceOver the years, the only thing I've done is update the vers...
I have this configuration: event manager applet clear_nat_1event track 1 state any maxrun 40action 1.0 wait 35action 2.0 cli command "enable"action 3.0 cli command "clear ip nat trans *"action 4.0 syslog msg "WAN Failover, cleared NAT" I have the max...
Download BGP Routing Protocol With 16 Practice Labs. Table of Contents Lab 1: MED and AS-Path PrependLab 2: BGP Local PreferenceLab 3: BGP path controlLab 4: BGP ConfederationsLab 5: Bestpath as-path ignore and aggregate-addressLab 6: Community Attri...
ARE THERE ANY COMMANDS WHICH WILL GIVE THE CHASSIS SERIAL NUMBER AS OUTPUT, FOR ROUTERS? ALSO, IF ANYONE KNOWS A COMMAND FOR SWITCHES THAT WOULD BE HELPFUL.
We would like to leverage the existing ESA to be used as a UAT SMTP, but we want to restrict emails from the UAT application to send out to external (Internet) while maintaining production emails to send to external. Could you please advise how do we...