Buy or Renew
Buy or Renew
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
2117011members
1454155discussions

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

Switch synchronization delay

We have a stack of IE 9320 switches as mentioned below:1) IE-9320-26S2C2) IE-9320-26S2C3) IE-9320-24P4S4) IE-9320-26S2CAll are in stack and in install mode and running IOS-XE 17.12.05When we power cycle switch 3 and switch 4 in the stack, it is takin...

grapevine by • Level 1
  • 177 Views
  • 4 replies
  • 1 Helpful votes

C8200L-1N-4T and NIM-2FXSP (Voice)

Hi team, I have a device: C8200L-1N-4T and NIM-2FXSP. I want to "show voice port" on CLI but it's doesn't work. I haved show the commands "show inventory" and confirmed that the NIM-2FXS module is detected, so why am I unable to run the show voice po...

HatDauNho by • Level 1
  • 51 Views
  • 1 replies
  • 1 Helpful votes

NX-OS Always On VPN Access not being provided?

Good day,At the risk of a possibly very obvious answer, I'd like to ask whether we are supposed to be provided VPN access credentials when launching the NX-OS Always-On sandbox. When launching, I do receive an email stating that it is starting and to...

vbacon by • Level 1
  • 36 Views
  • 1 replies
  • 0 Helpful votes

Python version used in Nexus 9000 ACI-Mode

Background:  Recently an internal vulnerability scan was run at a client for compliance purposes and the Nexus switches (ACI-Mode) show up with vulnerabilities because of "Python Unsupported Version Detection".  They're currently running 16.0(4d), si...

Resolved! CIsco ISE 802.1x EAP-TLS authentication with Entra ID

Our customer exisitng environment all PC join to entra id and no any infra in on-premise Now. they would like to implement new Wi-FI with kind of this solutions but it's look like very new for us and less experience Therefore, may I asking in this co...

cuiL by • Level 1
  • 2055 Views
  • 17 replies
  • 0 Helpful votes

SD-WAN Unlocked: Your Guide to Catalyst Success

Join us for the Cisco Catalyst SD-WAN Expert Insights Series—your essential resource for mastering the fundamentals and best practices of your Catalyst SD-WAN solution. Whether you are new to SD-WAN or need a refresher, this four-session series guid...

libledso_0-1760551828508.png libledso_1-1760551955694.png libledso_2-1760552028470.png libledso_3-1760552091401.png
libledso by • Cisco Employee
  • 1118 Views
  • 2 replies
  • 2 Helpful votes

Resolved! Choice between Routed Access Network and switching Network L2

Hello Support,I have a LAN with a Distribution switch 9300 and Access switch 9200. 9200 series support L3 routing, my question is about implementing L2 network with Trunk or implementing routed access Network with OSPF. which is the best architecture...

Adding second 150AX to network not working

I have a small office network with an existing CBW150AX-E-EU AP. I'm trying to add another CBW150AX-B-NA AP to the same network. It is a single VLAN network with a switch and an ISP router with DHCP service.The new AP powers up and boots to a conditi...

Load more