Application Networking

Cisco's description of the ACE-UPG2-LIC and the the release notes state that only the ACE20 can be upgraded from the 8Gb license to 16Gb. Is this accurate?There is a post in this forum from Sep, 2007 that states the ACE10 and ACE20 are the same hardw...

We're consolidating several pairs of BigIP's into the ACE. Would it be logical to map a BigIP pair per an ACE context? Thanks.

Hello Everyone,I have an Oracle server that's located in South America, Chile. The client sits in Rye, NY. The latency to the server is about 238ms. We are using 2 WAE-7371(s) in Rye and 1 WAE-674 in Chile. All devices are running version 4.1.1d. The...

Hi All,My WAAS solution was purchased with 2 Enterprise licenses for the application accelerators and 1 CM license for the central manager. I am now looking to upgrade to the 4.1.3 code and my questions are:1. Will the CM license purchased earlier be...

Hi all,After connect the cables in the inline card, i got this error message in console.wae#Uhhuh. NMI received for unknown reason 3d on CPU 0.Do you have a strange power saving mode enabled?Dazed and confused, but trying to continueAny ideas ?Best R...

Hi, I'm having trouble getting my ACE 4710 configured - you can ping the VIP but cannot http to the VIP address and see the servers. I have an admin network, a client network and a server network - all with layer 3 interfaces on my 6509 that connects...

I gather that a connection through a WAE can be in pass-through for one of 3 reasons : - the remote WAE is not detected through the 3 way TCP handshake (conn type 'PT No Peer' - the connection already exists (conn type 'PT In Progress') - the connect...

Hi All,We have 2 CSS in redundant VIP. Can somebody explain the meaning of the error message?Also at several times the services on the active CSS will stall and you have to make the standby CSS active in order to make the services run again.Please ad...

Hi, When I try to do ftp/scp ths gssm backup file to my management server, I see the following TCP Reset-o error on FWSMJun 18 2009 00:08:25: %FWSM-6-302013: Built inbound TCP connection 145712151624840974 for OUTSIDE:GSS/63558 (GSS/63558) to DMZ2:PC...

Does anyone know where I can find a list of steps to upgrade? We have 5.1 and I want to upgrade it to 6.0.Are there any caveats that I need to be aware of?Thank you in advance.

Does anyone know if the latest version 6.0 supports the latest WSDL standard WSDL 2.0? The 5.1 version only supports WSDL 1.1 standard.

While i am on roll here.Does anyone have an example config for ether-channeling the 4 ports into a single switch ?How does the FT work - seems to me that you need ft conf figured on an interface - this will not add to the channel-group..again any sug...

We need to see the original ip addresses of clients in our IIS logs but the ACE is NAT'ing them. How do I make this stop? Any help is greatly appreciated.

I am trying to send traffic to one server or another based on the URL. I want traffic to foo.com/selfserv to direct to server A and traffic to foo.com/webui to direct to server B. I found URL inspection etc but I am not sure how to apply it the sce...