Hi Folks, I added another rspan monitor session to a stack switch with an existing monitor session that has been running for years. rspan vlan is 200 voice vlan is 4 port G2/0/17 is just a pc active with one application open, but no one actively dri...
Forum Posts
I found message on " show platform crashdump" before device reloaded itself || switch running with "cat4500e-lanbasek9-mz.152-2.E8.bin" %C4K_SWITCHINGENGINEMAN-4-VFETQINTERRUPT: FATAL ERROR - VFE TQ dblStatusParErr interrupt. valid: 1 addr: 0x2...
The same problem is for version 9.8(3)16 on ASA 5545x
Please note that this _MAY_ be due to failed eUSB (flash) device. Have a look at the system messages (dmesg | grep sdb) and check if the OS reports any bad blocks. This command (in expert, aka linux shell) will immediately show if ANY disk is mounte...
Hello everyoneI have some problems with connection to the WLAN. Issue happens sometimes. I observe device disconnection, and i don't know why. With a 'debug client <MAC address>' command on the WLC, i observe the following logs when the device disco...
Here is the issue.. Cisco ISE 2.1 patch 3 context visibility page gives the following exception Unable to load Context Visibility page. Exception: blocked by: [SERVICE_UNAVAILABLE/1/state not recovered / initialized]; Cisco document says its a bug a...
Hi, Does anyone have any clue what module CSCvc46415 crashes on ? I have CIPC 8.6.6 crashing, on many installs, in: faulting module name: MediaTermination.dll Exception code: 0xc0000409 Fault offset: 0x00076480 Faulting Process id: 0xecc pity the...
Hi Security Folks, I need to know basically what is the default behavior for the "Flow-offload" feature for the FTD 9300 version 6.2.3.4 (Build 42), FXOS 2.3 (1.108) and ASA version 9.9 (2) 15 if the flow-offload service itself is enabled but we di...
When can I fix it?I have three customers who have encountered this problem. This feature is super easy to use for multi-video hosting companies.
Does this CSC#/issue imply that a blanket no split tunneling policy is not possible with IPV6 at this point in ASA/AnyConnect releases? Any one have any feedback on this?
Hi Team, Getting below error while saving the configuration Unable to save the configuration due to error '' Unable to open flash config.txt.new'' I can see below below bug detail but i can;t see details CSCto07667issue with two of his 2x3750 ...
A possible workaround: If you have the ability to create a DNS entry and affect the response based on topology records (such as the querying DNS server) you could in essence create a specific response for your region the DNS server(s) are responsib...
The bug only refers to documentation. But in fact, it is also not working either. Since we upgraded to 9.10 with or without rfc5424 option in the new logging timestamp command, it sends some log messages with the rfc compliant option and others not. ...
Hi, we have the same issue that seen error (Last reload reason: critical process exit with reload fru code, cpp_ha_top_level_server, fp_0_0, rc=69) but this happened in version 15.6 so please need your help to solve this repeated problem
Tengo un ASR 1004 con el mismo caso el crypto engie inactive, cuando encryto un tunnel queda down y si reinicio el router queda en un loop con un crash info.
