HelloI suspect that there is some kind of a problem with CML. What do you think why is this happening ?There is no VTP and only VLAN 1. When I shut the lab down yesterday, everything was working as expected.It was IOSvL2-3-Root IOSvL2-3-3 was blockin...
Hello Team, I would like to know if there is a roadmap planned for Cisco to introduce a new image of CML 2.x to work with the new M1 Mac silicon architecture via VMware Fusion?As of now, the solution is not compatible. Thanks for your answer.regards,...
Hello, I am setting up an easy lab for inter-vlan routing using a router on a stick in CML. pretty straight forward, right? not able to ping across sub-interfaces from the root switch. can ping 192.168.0.17 from switch, cannot ping 192.168.129 from ...
I've just switched over from GNS3 and trying to get going with CML2. I see a few useful features that may come in handy, but there doesn't appear to be any documentation on some of it. Can someone help me by explaining how "Update Configuration from ...
folksi'm looking at trex in cml and have managed to generate traffic by connecting the eth1 port onto the same lan as the device i'm testing but i want to push traffic through the device to an endpoint across the wan and so have some questions- my tr...
I am new in using CML. Just bought it and install it.I make a router iosv connection between two router. I set in the same network IPiosv9 = 192.168.2.1/24iosv8 = 192.168.2.4/24It should be able to ping each other in one network.But when I try to pin...
Hi,I am not able to use ASAv in CML-P v.2.0 on my Vmware-Workstation. No problem with switches and routers.Any idea how to get this working?How do we get support from Cisco for this product?
We are looking at purchasing 4 to 5 CML Personal Editions to use in our VMware Lab. The Lab is air-gapped with no internet access. Can I build the CML VMs on an ESXi host that has internet access, activate / register the product, then export the VM...
Cannot upgrade OS in CML 2.2.3 anymore, as CentOS 8 has been deprectated on 2022-01-31.All CentOS 8 mirrors are gone. Fetching packages in CML-controller fails.What to do now?
I have successfully started an F5 BigIP in CML2.0. However, how do I access the F5 web based configuration utility from CML? Thanks!!
I've been using CML however, when I upgraded to a new PC, my CML now says it is not registered. So I tried to register it using the token that I got, but when I did, it now says "compliance error". The advised step is to de-register CML. I've done it...
Hi folks, I've got a quick question concerning layer 3 switching and specifically the command 'ip routing'.This command normally would enable the ip routing protocol on a switch, basically turning a layer 2 switch into a layer 3 switch, right? But as...
I cross-posted this on the Cisco Learning Network's CML-P forum but have yet to receive any replies. (Which is the best place for CML-P support questions?) We have a clean install of CML-P that loses all router configurations (IOSv and IOS XRv) when ...
We are setting up a test environment in vSphere that will use VMs and need to emulate customer’s physical switches and routers.We have CML running on an ESXi Server.As a first test, a customer has provided us with a 3850 fiber switch configuration fi...
Deregistered old and Registered a new CML2 server. I am getting out of compliance although I have deregistered the old environment. Cannot use my environment now.
