Hello, I am working with a CBS350 series switch that is up to date on the latest firmware. I am trying to enable the CBD probe to check into the dashboard, which was also recently updated to the latest version. I run through all the steps as provided...
I have an older aruba switch with a sfp port and a multimode fiber connected to it.then I use a networkcable to the CB250.on the other end of the fiber is a CB350.when I connect the fiber cable from aruba to CB250 I get link up, but no internet.on th...
Hello, I recently got a CBW 140AC for my homelab, its main purpose was to move all IoT devices to their own network; incase one of them gets hacked. However, I managed to migrate everything to the new IoT Network except this darn HomePod Mini, the HU...
has anyone configured a cbs350 switch stack to work with Microsoft NLB in multicast modeI have found the the cbs350 does not allow adding the multicast mac address (complains illegal) to the mac address-table and does not allow adding it as a static...
I am currently facing an issue with one of my ikev2 vpns. The issue is that some remote ips that are on the vpn are unreachable (these were working earlier) and giving send errors on phase 2 output when i try sending any traffic. On the phase 1 it sh...
This is related to a previous issue I posted here "titled issue-getting reply traffic back from our cbs 350 switches".I have three VLANs defined on our CBS350 switches and sub-interfaces configured on our router (PaloAlto firewall) with all policies ...
Greetings, I'm creating a system that requires a TAA(Trade Agreement Act)-compliant switch be used. I have a SG500X-48p, SN: DNI181602C0. How can I verify whether the device is TAA compliant? Thanks in advance for any responses.
The management function of 240ac Wifi accesspoints does periodic radius requests with a user named "cisco-probe". Part of "Active Fallback" radius mode.Currently these requests fail, and fill up my logs.Which password does this "cisco-probe" user hav...
I have tried multiple instructions on resetting this switch (Cisco 2960L-24PS-LL), but nothing I do works.I have held the MODE button while powering on the switch for various intervals (from 15 seconds all the way up to 2 minutes)I can access the con...
Hi I have an SG500-28P that is behaving oddly. Factory Reset via button on the front took ages to respond, I have been told 10 seconds or above and it should flash all lights and reboot. It does not. Finally got it to reboot and now it goes through t...
Hi there,We have recently installed a Cisco Webex Room Bar Model: CON-ECDN-CSBARMPN. We seem to be having an issue getting audio out from the sound bar. We can see the camera & the microphone but no speaker. The navigator is been used for BYOD only a...
I just purchased a Cisco CBS250-24P-4G 24 Port Smart Switch with the intention to mount it in a rack. The unit came with a mounting kit but the brackets force the switch to stick out more than an inch.Are there brackets that enable a flush mount so t...
Hello, what are "non-XG" devices that are referenced in the manual like in the screenshot i posted? I have a CBS250-24P-4X switch, does the "X" mean it's an "XG" device?