Good Afternoon all! :)I was wondering if anyone could lend me some assistance. I have installed my FXO module within my 2611 router and would now like to upgrade the ios so that it can support the voice but so far all the images seem to be way too hu...
Guysive just connected some VT Cams and my test users cannot dial out through their PRI.If i disable Video everything is fine. i understand that the command bearer-cap Speech should resolve the issue but im not seeing this command under the voice-por...
Does anybody happen to know the length of the cat5e cable included in the box with a 7965 phone? I'm trying to determine if it'll meet my needs, or I should order additional patch cables. Thanks!
Hi,I have a couple of 7971's that will not boot up, can't even perform a factory reset on the phones. I've tried booting up with a power block as well but all I see is the speaker light on and that's it!Is the phone now dead or is there anyway to re...
Hi all,I have the following set,I have a call manager 6.1 and a call manager 4.2 both are connected to a normal switch... i have 4 cisci ip phones of which 2 are configured and registered with ccm 4.2 and the other two are registered with CCM 6.1... ...
Hi There !I'd like to know if there is any "ATA" with FXO port.... I need to connect 2 lines from PSTN...Should I use a 4FXO card in a router ?Thanks.Andrei.
HI.I need to delete all voice messages in a voice box. I deleted all items in Inbox folder for the user but ip phone still show "you have new voice messages" message.I use Unity 4.0
Is there a way to force a busy no answer if I do not have a phone built? Example:IPCX, customer hits a button to transfer to voicemail. Hits CUCM and a line that is built for this. Line is configured for Call Forward all, which goes to Unity and p...
Hi All,I have two routers connected with PPP (256 kbps) leased line and going to implement QoS for voice traffic.my config is belwo which i got from cisco.class-map voipmatch ip precedence 5!policy-map llqclass voippriority 128class class-defaultfair...
Does VG224 used for wallphone and Fax need to config dsp profile for ccm? I have already 2 ISR routes with enough DSP resource configured with CCM. Shall I configre DSP again in VG224? I think I have enough DSP for xconding, termination and conferenc...
CCM use mgcp with gateway, I hope to add a PSTN access code(90) in the front of the calling number when inbound call, this can make agent dial back call easily. I tried to use translation rule in VG , and put this rule in each E1 voice port, whereas,...
Hi all. Im looking at implementing a call pickup group. Im wondering what is the usual implementation here. It seems like when you dial the pickup number, I should think that you should be able to dial the extension of the phone that is ringing. ...
We were purchased by another company we are running 4.1 they are running 5.1 we are on 4digit ext 2200's and they are on 1700's. What do I configure to get these 2 CMs to talk to each other gateway??? Any help would be greatly appreciated.
