IP Telephony and Phones

Hi,We have two sites using IPT, one site is installed with CM 5.1.3.1000-12 & on the other site we have 4.1(3). Already ICT - non gatekeeper has been configured, now we need to restrict maximum 4 concurrent calls between these two site & on the site ...

Hi,As I know that I cannot forward an incoming call to a phone to an external mobile number as it is valid to forward it to an internal extension.Is there a way to workaround?Thanks,Mo

For a never seen before star color!

HiWe are having CCM 5.X and the H323 GW& Phones located over the WAN.CUG calls are fine but there is 3 sec intial delay in the PSTN calls.CCM(L0CATION1)------>PHONES,GW(LOCATION2) WAN Please find the GW config and the ping & sh call ac...

Hi all,I need assistance with SIP configuration CCM 4.1, Recently I joined a SIP service Provide.How do I go configuring this up, Do I set a SIP Trunk directly to the SIP service Provider IP addresses?Or do I need a SIP gateway?Your Help will be much...

Hello,Is there anyway to present more than 100 entries in Local directory of CME?Any workaround, any ideia to overcome the limitation?Thanks,Met.

HiI used to login via web to configure CUPS 6.0.1 . But, now I cant login. Although, I can login to OS Administation page with different account. Is there way to create another account for application user or reset the password.thanks in advance.Moh

Can you use a bluetooth headset with IP Comunicator? Bob

Hi,i added a translation pattern on CCM6.01 for a specific extension based on offwork hours. This pattern should call an external Number.The internal Extension 99 are translated from .99 to external Number on called party transformation and discard p...

Hi friends,Is there any possibilities to make forward commands in CME, like FNOA, FBUSY to be applied only to calls coming from outside, and dont operate in internal calls?Thanks, Met.

I have a UC520 with Cisco IOS Software, UC500 Software (UC500-ADVIPSERVICESK9-M), Version 12.4(11)XW7, RELEASE SOFTWARE (fc2).I have installed a VIC2-2BRI-NT/TE interface Cards in UC520, now i have 4 ISDN Basic Rate interfaces.i want to use one of th...

I activated CFwdAll on my extension to forward all calls to my mobile. When I receive the call on my mobile I always see the main number of the line as caller ID if an external user is calling my extension. I know it is because the callmanager is sen...