Metro

Hi,I was hoping to glean some information from the community on the undocumented differences between the ME3400 and ME3400E. It's quite clear to see from CCO documentation that the newer E variant now takes field replaceable power supplies and fan mo...

Hi.I would like to take some questions about Cisco Metro 3750: The ES interfaces, as well as Gigabit SFP, support trunking VLANs?Can I give (access mode) interfaces VMANs from 10/100?Can I to manage rate-limit (in and out) on 10/100 interfaces?To my ...

Hi!I wonder if it's possible to run mark inbound traffic on L2 interfaces and then use CBWFQ on the q-in-q trunk's for bandwidth management ordo you need to have routed interfaces inbetween the two ME3600 switches to be able to use CBWFQ?

What is the reason Cisco decided to use EtherType 0x8903 in its FabricPath technology comparing with TRILL outer ethernet header with 0x8100?As I understand with TRILL I can gradually enable RBridges, which is not possible with FabricPath. Please cla...

I am new to metro ethernet and have two ME3600x switches.  We are connecting multiple customers between to locations  and I'd like to map them to different EVC's between the two metro switches at each location.  I am attaching a diagram of a proposed...

Hi all,we would like to use the  ASR1006 as ATM aggregation router, the customers connect to the ASR to use E-VPN serviceto connect to the main locations on ethernet backbone.     ATM                          VPLS       Customer VlanCE1-------ASR----...

Hi.We recently purchased a ME-3400G-2CS-A in order to do some selective QinQ. I have the full Metro IP Access license.I'm trying to follow the guide, but it isn't working.Guide shows:Switch(config)# interface gigabiethernet0/1 Switch(config-if)# swi...

HiI have to configure the EVC on 7613 with ES+20G.But i can not configure it because there is no the encapsulation configuration on 7613.So i check the relese12.2(SR) configuration note and then i know there is the encapsulation configuration on 7613...

I have a me3400 connected as follows:in port G1 / 0 fiber optic switch connects 7 WS-C2960-24TC-s.The switches are running vlans 2960 and serves to intervlan ME3400 routing.All of the GTW vlans are defined in the ME3400, in addition this does dhcp fo...

Hi,I have a testing scenario that seems no to work and I don't find eny clue.On switch 3800-B I have configured this two ports. To the port  0/8 I have connected a host with IP address and MAC f0f7.55cf.6201.interface GigabitEthernet0/8switchport acc...

hi is the 3750ME capab;eof running isis on ipv6.I only see support for rip and eigrp.thanks

Hi to All,I would to ask for support on how i can establish the PTP between Cisco MWR 2941-DC and a NSN NodeB. The Cisco MWR is connected to a Cisco 7600 with SPA-2X1GE-SYNCE where the SSU/OSN clock is connected on the BITS ports. Hope you can assist...

e3400 packet loss I have a me3400 connected as follows:in port G1 / 0 fiber optic switch connects 7 WS-C2960-24TC-s.The switches are running vlans 2960 and serves to intervlan ME3400 routing.All of the GTW vlans are defined in the ME3400, in addition...