We run Citrix at our remote locations. We have two circuits at each location. One is a point to point for backup and the other is an MPLS circuit that is our primary. Both circuits are T-1 speeds.We have all thin clients at our remote locations. ...
hi experts.. does anyone know why traceroute trough MPLS resulting 2 similiar hop as below.hop1 = home cehop2 = home pehop3 = remote cehop4 = remote ce (this is twice)hop5 = remote hostfurthermore, i can't see remote default gateway for net 10.193.28...
Need some advice on connecting 2 MPLS networks together from two different ISPs. The compnay I am working with is using AT&T MPLS and they aquired a smaller company using SBC MPLS. We want to connect the two networks together for the shorterm and eve...
Hi Team,We are using the IPLC links to connect our office in US,our network in india is natted to the public ip in the pix which is in US office as i donot have internet in my india office,we have a MPLS link as a backup to US office to access the US...
Hi,I have a Cisco 7204VXR with a NPE175 and 64 MG. I am using the IOS c7200-js-mz.122-32.bin. My problem is that I cannot form the VRF in "ip nat inside source list 2 interface loopback 2 vrf XXXXX overload". The commando vrf does not appear to me. A...
H-VPLS on a 7600 Series requires both the WAN Facing Module and the LAN Facing Module to either be a OSM, SIP-400/600 with SPA cards, or a Ethernet Services 20G Line Card (ES20), whereas plain VPLS only requires the WAN side to be one of the above mo...
there are about 1400 routes in the VRF RIP database on PE, approx 30 DSL routers(Cisco837 with same configs) connect PE via RIP V2. The problem is some CE routers receive the whole routing table, but some only get partial routes. is it weird? has som...
So I have TE configured on an EoMPLS VPN, but it doesn't seem to be throttling anything.Traffic is only throttled if I put a service-policy on the PE subinterface.When you set the ip rsvp bandwidth on the PE-PE interfaces and specify tunnel mpls traf...
Hi guys,I'm tring to test interoperability between Cisco an Juniper Boxes aboutpseudowire services.Let assume that I've an MPLS backbone, where the label distribution protocol used is RSVP, then MPLS-TE tunnels, I do not want to enable LDP on my back...
I'm trying to leak some static routes out of one VRF into several others. This is mainly to help get around issues with FWSM shared interfaces and load-balancing the firewalled traffic. Anyway, to try and ease the administration of the static routes ...
Hi. I am having some problems with VRF aware NAT. I have followed the Cisco documentation, but i'm still having problems with dynamic nat. The scenerio is i have a VRF called CUST1 which i can NAT if i use static vrf NAT, but not dynamic. The configu...
hi,allA router 805 that is regarded as CE to MPLS/VPN. the router only support 512K bandwidth on its Interface S0,and the MPLS line bandwidth to CE is 256K,It always discards data packets when I ping to peer after connected the router to MPLS network...
HI,I am configuring GRE tunnel between two PE's but tunnel is not coming up please advice how to proceed,Configuration of PE1;3845]interface Tunnel100ip vrf forwarding DCN-NECip address 10.1.1.1 255.255.255.252tunnel source 192.168.104.250tunnel dest...
