Network Access Control

I am attempting to set up a couple of different user levels in are ACS server. Group 1 will have all privilages (15). Group 2 will have limited access to command sets (help desk folks). I was hoping I could avoid putting any "privilege exec level" co...

I am trying to get multiple users to use the same machine but have different vlans assigned. i.e if user 1 logs in he gets vlan 1 if user2 logs in he gets vlan2. This works fine if I reboot between users, however, if I do shutdown, log off user1, the...

i need add some branch routers as clients to the acs server. so when choosing the ip addresses of these routers, which interface's ip address should i choose?if i use these routers' loopback interface ip address, should i add any other command beside...

I have tried without any success to get a PDA running pocket PC to authenticate with a VPN3000 using an RSA token. I believe this has worked in the past, but now with VPN3000 sw ver 4, movian ver 3 and RSA ACE ver 5, the authentication fails between ...

How can I setup, view a report that tells me the last time a user logged in ?

can somebody give me the steps to configure CAS2.6.2 and router 2600 with 16 modems.i wana configure it with tacacs+ and want to work fine with normal dialup and callback user.

I have 2600 router with 16 modem and ACS 2.6 tacacs+ on windows server.i wana setup dialup and callback on these can any one tell me how and what are the steps ....please paste the config if any body has already configured.

I work in a facility that has some strict access control requirements. I am looking for a way to log into a Cisco router that requires two usernames and passwords to access the privilege level. Does anyone know of any way to do this? I can't seem to ...

How can i pass to the remote client the Dns Ip address and the domain name prefix with Csacs Radius Server?Thanks

Hello,I'm going to replace a CiscoSecure for Unix with a CiscoSecure 3.1 for Windows; I'm using radius authentication/authorization/accounting.On the reports on Unix version I can see the disconnection cause, instead on windows the only way to see it...

Hello All! I have an ACS where I authenticate VPN user using Cisco vpn client. We tried PPTP with a group and a user local (internal) on the VPN concentrator and it doesn`t authenticate correctly...I change the order of my authentication servers from...

I am pretty new to the VPN world and have a question about access to our network from remote users.We have a Cisco VPN 3000 series. We have approximately 4000 employees. We want any employee to be able to be at home and have access to our network. I ...

We purchased ACS3.1 and will like to use NDS as the external database for authenticating dialing-users. This configuration is working fine, but now how can I restrict a specific dialing-users from authenticating to NDS.

Hi,i have a very big problem with my pix 515 version 6.2 (2). I have just installed and configured it. I configured acls to permit ftp from inside to a server in dmz, and permit smtp from inside to a smtp server in Internet. Both requiere authenticat...